How to Replace the Inner & Outer Tie Rods on a 2002 Toyota Camry

Easy to follow step-by-step guide on how to replace your inner and outer tie rods. If you have any questions, drop them in the comments below and I'll get back to you when I can.
Tools Used:
-Pry bar.
-Ball joint separator.
-Rubber mallet.
-3lbs sledge hammer.
-4lbs sledge hammer.
-1/2in ratchet.
-1/2in extension.
-Inner tie rod remover/installer w/ adapter.
-Large water pump plier.
-Two different sizes of present wrenches.
-Long nose plier.
-Side cutter.
-17mm wrench.
-7mm wrench.
-Pneumatic grease gun.
-Silicone spray.
Parts Used:
-Outer tie rod.
-Inner tie rod.
As always make sure you subscribe, give me the thumbs up, and share with your friends & family! Thanks for watching, aloha!

[@larryjensen1388]

Very clear and precise
I like the way you use the water pump plier

[@RoysGarage808]

Thanks for always watching 🤙🏽🤙🏽🤙🏽

[@mahamudfidow7352]

It's very clear how you explain
Thanks for your help appreciated

[@kycatfishguy671]

Had to break out the grinder to cut off the outer tie rod nut off because it was spinning out on me and cut off the lock nut as well because everything was just so rusted. Tried penetrating oil, heat it up with a torch. But I was changing both inner and outer and it made my job a lot easier. I definitely still enjoyed your video and it helped me do my first ever tie rod job. Now off to get an alignment

[@ThothTheAtlanteanK]

Roy, you're a great inspiration! Love the video!

[@conormccullar4797]

Wonderful video. Thank you for taking the time to make this. Just what I needed.

[@RoysGarage808]

Thanks for watching 🤙

[@roltyd22]

Thanks for the video!

[@jetd6764]

Thank you, thank you. Great learning tool. I have more confidence now. Can a bad tie rod end vibrate the front end at high speed? God bless u and the family.

[@enriquemartinez16]

Outstanding!

[@terrybo5924]

forgot to mention the torque specs for the install on the inner tie rod end and the castle nut for the outer tie rod end before putting on the cotter pin.

[@dannysautorepair]

Great job sir

[@scooter12368]

Jam nut question: i am trying to remove jab nut on my dodge van.
you appear to be turning clockwise to loosen the nut and counterclocwise/tighten the nut.
Is that true?