2013 Buick enclave camshaft position sensor replacement
Вставка
- Опубліковано 7 вер 2024
- replacing bank 1 camshaft position sensor on. buick 3.6 liter VVT. I misspoke in the video. Bank 1 is the rear bank closest to the vehicle. Bank two is at the front of the engine.Bank 1 and Cylinder 1 always correlate.
Bank 1 is in the back
You are correct...was thinking of a different vehicle in reference to cylinder 1. Thanks for catching that
is there a relearn procedure?
Not at all....disconnect the negative battery cable before changing for piece of mind
What happens if you don’t?? I did it after and took the ecm fuse out
Shouldn't be an issue..you should be good
Will this fix Camshaft Position
Correlation Bank I Sensor B, so the last 2 sensors are bank 1
Bank 1 is the front of the engine. Bank 2 is the rear. It should fix your issue when they are replaced
When you replace the crankshaft sensor do you have to do the camshaft as well? Getting code p00017 still and won’t start.. cranks over..
What kind of car?
2011 Buick Enclave
P0017 is dealing with a correlation issue between the crankshaft and camshaft sensors....you can try replacing the camshaft sensor also but the bigger issue may be the timing chain may be stretched and slipped. Tooth which would cause the sensors to be out of alignment. It could also be the wiring harness attached to the sensors are damaged. I would start with the camshaft sensor as it is also included on that code. If that's not it you may need to check the wiring and pray it's not a timing chain issue
@@wedoitall7676 so something I shouldn’t do right lol
@@jerigundrum4636 it's really up to you. I hate throwing parts at things but they do work together so it won't hurt...
Bank 1 or bank2?
Bank 1 is shown in the video. I also show you where bank 2 is. Bank 1 is towards the front of the vehicle, Bank 2 is towards the firewall
Might as well change both
@@rhurtadorh32 agreed
@@wedoitall7676quick question are all 4 sensors the same? Or they diferent?
@@rhurtadorh32 all the same