Staple System Preparation & Installation

👉 If you find this video helpful, PLEASE SUBSCRIBE
👉Visit our website multipipe.co.uk/ for helpful guides
👉 Call our dedicated support line on 01245 850799

In this video, Martin and David take you through the steps for installing underfloor heating using the standard staple system. Showing also how to lay a Bifilar pattern (also known as a snail pattern) this gives a more even heat output, is easier to lay with closer centres and works best on higher delta T's. This video shows the entire process of laying insulation onto the DPM and subfloor to the end connection and we have not demonstrated screeding as this is normally carried out after filling and pressure testing.

Steps for Installing Underfloor Heating Using the Staple System:

0:10 - Roll out edge insulation around the perimeter of the room.
0:56 - It’s a good idea to lay a polyethene sheet over the entire board.
1:00 - Next untuck the polyethene skirt on the edge insulation and tape to polythene sheet.
1:11 - Mark up the floor with the pipe centres from your drawing.
1:58 - As you lay the pipes use clips to secure the fitting.
2:58 - Once complete make a final connection to the manifold.

For more information or for help with Multipipe products please get in touch today via:

Dedicated Support Line - 01245 850799
Alternative phone number - 01245 227630
Website - multipipe.co.uk/
Twitter - / multipipeltd
LinkedIn - / mult. .
Facebook - / multipipelim. .
Instagram - / multipipeltd

#heatingsystems #smarttechnology #plumbing #multipipe #plumbers #knowhow #rightfirsttime

[@hardcooling]

Can someone tell me why at every doorway they put a hose over the pipe at each doorway entrance

[@MultipipeLtd]

the use of a conduit over the pipe serves two purposes. 1. in areas with high feeds it help to limit overheating 2. this conduit can be used where you have an expansion strip to allow the pipe to pass through without affecting the strip. (I believe this is what you refer to)

[@hardcooling]

@@MultipipeLtd yes thank you for getting back to me 👍🏻

[@MultipipeLtd]

Any questions about the installation process? Let us know in the comments.

[@hardcooling]

If I were to send you a drawing of the house would it be possible you send me a ufh layout plan I have two separate manifolds already installed just waiting to install the actual loop pipes

[@MultipipeLtd]

@@hardcooling unfortunately, we can only design systems based on the use of our system materials. However, if you speak with whoever you ordered your system from (providing they are reputable) they will offer a system design service often for free.

[@RelaxingMusic-mp8lq]

How 6 pipes on 1 flor on main unit?