Briggs & Stratton Quantum Carburetor Repair
Вставка
- Опубліковано 4 жов 2024
- How to remove, clean and rebuild the carburetor on a Murray 22" self propelled mower with a Briggs & Stratton 6.25 hp Quantum engine.
DISCLAIMER!
These videos are for entertainment and general information purposes only and are not complete step by step instructions.
Attempt this at your own RISK. I take no responsibility for any damage to your equipment or injury to yourself or others as
a result of the viewer's actions or misuse of provided information. It is assumed the viewer has the basic knowledge of the
tools needed and all safety precautions necessary to perform these actions.
You can contact me by email veteranssmallenginerepair@gmail.com - Навчання та стиль
This video never gets old, unlike the carburators...
Thanks!
Just the information I needed! Thank you!
Glad it was helpful!
Quantum carburetor? Jesus Morty, you can't just add a sci-fi word to a car word and hope it means something.
The mower model is called a Quantum. Thanks for the comment!
@@veteranssmallenginerepair5934 It's a reference from Rick and Morty S02E06.
Excellent tutorial!
Thanks for watching!
Would have been a lot better if you had some light on the subject so we could see what your doing.
Thank you for this video I’ve just inherited my first petrol lawnmower lol but yes the mower was in the shade so need to have sunlight or light on it. Next time please
on that quantum engine, should the butterfly be closed when starting? I have the primer bulb and governor seems ok? Any ideas? Thanks
Yes.
It runs for a few 2nds when you put small amount of gas in the cylinder but dies. It has spark and compression Did a complete clean and rebuild on the exact same carb. I have 2 brand new gaskets on the back of the air cleaner housing attached to the inlet of the carb. Are you saying if that doesn't form a tight seal the gas wont flow into the carb? Does that include the O' ring on the outlet of the carb?
Clean the backside of the air cleaner housing before you reassemble it onto your cleaned carburetor so that you don't introduce dirt or gunk into your cleaned carburetor.
Cheers Mate.
Thanks for watching and commenting!
Great video and very simple instructions. I did every step in the video and my mower still will not crank. I even put a brand new spark plug in after Carb rebuild and it still refuses to crank. Help please
Here are some of the things you need to check.
1. Compression
2. Spark
3. Fuel (new and clean, less than a month old)
If you have all of these and it still does not run then you probably need a new carburetor. Not all of them come back after a rebuild.
All of this is assuming you have not had a catastrophic failure.
Thanks for watching and commenting and good luck!
It’s probably the magnetometer not producing spark. Or the cable is wore out not pulling the arm over all the way over to complete the circuit. Hope this helps it happened to me as well.
Not to be nit-picky but the emulsion tube emulsifies the air/fuel mixture. Vaporization is different.
Your phrasing is correct. Thank you.
could have done this without the damn back ground noise of someone mowing? WTF, poor planning. FUSA