Outdoor Curtains DIY - Make Your Own Hooks and Rods ***No Holes
Вставка
- Опубліковано 25 сер 2024
- This is a great easy DIY project if you have a patio or outdoor space that gets hit by the sun and you need to shade the area. In this video I show how I built a curtain setup with rod and hooks without drilling any holes and for cheap.
Get the product here and shop for products I use and recommend on my Amazon Storefront…. www.amazon.com...
Direct Contact: how2togo@gmail.com
Disclaimer: Due to factors beyond the control of “How2ToGo”, We cannot guarantee against improper use or unauthorized modifications of this information. “How2ToGo” assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. “How2ToGo” recommends safe practices when working on vehicles, properties and or with tools seen or implied in this video. Due to factors beyond the control of “How2ToGo”, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not “How2ToGo”.
Best cheap hack I've seen. I'm going to use this hack for mine, too. 😊😊Thanks
Wayfair has the nicest inexpensive outdoor waterproof curtains and they’re not torn or faded
You are a genius
If you undo the bottom hem about an inch you can add sand down the length of the bottom hem. Just enough weight to keep the wind from blowing it around to much.
Absolutely what I need for steel gazebo! Thanks so much!😊
It helped me and now I can use curtains on my metal gazebo. Hanging curtains on the ends. I will not need to open them, just tie down. Thanks
Amazing job exactly what I needed thank you for sharing
Great job. I'm trying to do this but it's just a lot right now.
I need a handyman lover... is exactly what I need for my pergola. 😩
Thanks a lot! This was super helpful and funny too!
It wasn't meant to be funny, maybe. But I like your dog.
@@how2togo the jokes were funny! My dog liked it too!
Beautiful job
Thank You for sharing 🙏🙏🙏
Bend the aluminum to give you the clearance you want from the fascia board.
inspirational 😊
YOU MADE A RIGHT MESS WITH THAT
What is the thickness of the 1" x 10' Aluminium? Is it 1/8" or 1/4"?
Amazing work. Quick question, has the pvc bent or begun to sag?
It has I hate to say. If it was shorter it would of held up I think.
I've been looking for ways to do this with it hanging down about 8 inches because they're 84 inch curtains
This was entertaining lol
Those pvc pipes didn't sag in the middle? They're not very rigid.
You lost me when I saw the Porsche in the garage….
Lol
the video's "GOOD ENOUGH" attitude is exactly what separates Quality from Eeehhhhh.... too-funny!!
So, is the second curtain also made in China?
Yep
Those 1st curtains were definitely used 👎
You said no holes. But you put screws in.
So you went on Amazon and bought cheap curtains then got mad that they were actually 'cheap'.
Lol, but I went back on and bought cheap curtains again and they were ok.
Nothing to do with china.. they were used and returned. And uaes for aleast a year. My old curtains look the same.
Whered you get the aluminum?
Home Depot