Good to see more progress!! and auto to manual swap on gen 3 integras are so hard to find I appreciate this alot and cant wait to see the finished product!!
We're about to swap a 98 integra ls to manual, and i have been watching your videos to figure out everything i need. They are super helpful! Thank you! I hope everything is going well with your swap!
Mine was difficult to get lined up but I wouldn’t say an inch off. I attached the mounts to the trans/motor then bolted it to the chassis mounts. I’d be 100% sure you received the right part.
Good to see more progress!! and auto to manual swap on gen 3 integras are so hard to find I appreciate this alot and cant wait to see the finished product!!
We're about to swap a 98 integra ls to manual, and i have been watching your videos to figure out everything i need. They are super helpful! Thank you! I hope everything is going well with your swap!
Great to hear man! I’m trying to upload more. Thanks for the support
What is the length of the bolts that you're using for all the motor mounts?
@@a.r.1066 I used the stock bolts for all of them except for the one that mounts to the transmission. I just picked some up from Ace hardware.
Did you re use your automatic axles and intermediate shaft?
I believe the half shaft is different but you should be able to use the auto axles. I ended up getting new ones.
Hey I’m getting ready to put my engine in but I’m trying to find all the mounts. You think you can share a link to where I can get them all at once
I actually ended up ordering the auto to manual mount separate from the set. Hasport is the only place to get the whole set
What can I contact you on so u can show me the right ones?
I have a 95 integra I’m doing a auto to manual rn and all the mounts fit except the passenger side tranny mount it’s like an inch off
Mine was difficult to get lined up but I wouldn’t say an inch off. I attached the mounts to the trans/motor then bolted it to the chassis mounts. I’d be 100% sure you received the right part.
Was it the mounts or what did you end up doing?
Did you ever figure it out? I'm currently having the same issue, I think I gotta take my studs out and replace with bolts like in the video
You know the t bracket size ?
Not sure the size. All I know is you NEED one for the manual swap