(Worked GREAT!) O2 sensor - mini cooper rough idle and engine check light fix

Поділитися
Вставка
  • Опубліковано 18 січ 2025

КОМЕНТАРІ • 32

  • @hakankeskin9566
    @hakankeskin9566 Рік тому +1

    Amazing video! did you have the same "check engine" issue after this replacement?

  • @michaelherbert2982
    @michaelherbert2982 2 роки тому

    Hey bud ...brilliant vid...just a quick one..what are the two leavers ..with LESHP wrote on them .

  • @andreasf5882
    @andreasf5882 2 роки тому +1

    same here, rough idle, my mini is R56 2008 Year, didnt have much power when you go highway, needs more fuel i think.....my fault code is P0141 o2 sensor (sensor 2 bank 1)

  • @tm5346
    @tm5346 3 роки тому +2

    Thank for informative videos!

  • @TheRedgtv2000
    @TheRedgtv2000 4 роки тому +1

    Sometimes they can be very sensitive to some parts, unless you use the original parts. One example is the after market thermostat!

    • @gompro4943
      @gompro4943  4 роки тому

      Hi, thank you for sharing your experience! I was trying to save some money by using some aftermarket parts. In my case, somehow the thermostat housing was perfectly working so far. I bought one from amazon and looked pretty much similar to the original. :) I might be lucky! By the way, do you own Alfa Romeo? My first car was a 96' spider and I pretty much liked it, regardless it is reliable or not.

  • @makaio8688
    @makaio8688 2 роки тому

    Hi! This part was the upstream sensor right?

  • @othmanihela7588
    @othmanihela7588 2 роки тому +1

    Hello, Did you have a smoke issue before changing the sensor?

    • @hakankeskin9566
      @hakankeskin9566 Рік тому

      I also have the same vehicle. yes I have the smoke issue

  • @aaronwilsonpt
    @aaronwilsonpt 2 роки тому

    How do you unplug the 02 clip? I’m not seeing what side I need to push in to unplug it

  • @jvst20051
    @jvst20051 3 роки тому +2

    I wanted to see the symptom

    • @gompro4943
      @gompro4943  3 роки тому

      I don't want to see the symptoms again! If I see in the future will upload it.

    • @jvst20051
      @jvst20051 3 роки тому +2

      @@gompro4943 lol I know bro but before replcacing parts ppl wana see also symthons in my toyota it turned out to be the ecu

  • @bigo-b
    @bigo-b 2 роки тому +2

    Great job removing that electric wire housing gives room to work on removing the sensor! Will remove and clean both the sensor and the cat with crc throttle cleaner

  • @fonic111
    @fonic111 3 роки тому

    Hello mate i have a problem with white smoke from exhaust and he loses sometimes a bit of power (mini one 1.4 90hp 2008) but there are no water/oil leaks. New glow plugs,filters,oil coolant

    • @gompro4943
      @gompro4943  3 роки тому

      I would check O2 sensor and plug. GL!

    • @flycatchful
      @flycatchful 3 роки тому +1

      Head Gasket needs replacement.

    • @abh1945
      @abh1945 3 роки тому

      Do a compression test first

    • @rfcasey
      @rfcasey 2 роки тому

      Always diagnose first. There could be many things causing your issue. Run a scan with an ODBll tool. You may have warn valve seals, your fuel mixture could be rich (check fuel trims) or you may need a new PCV valve, bad rings (compression test) or head gasket( look for exhaust gas in antifreeze fill or do the chemical test) Best of luck

  • @huertafabian68
    @huertafabian68 3 роки тому +1

    Did it fixed your issues after putting new sensor

    • @gompro4943
      @gompro4943  3 роки тому +2

      It became much powerful. I am so happy with this fix. Strong enough to slip my tires :)

  • @raftheleo
    @raftheleo 2 роки тому +1

    NiceWork!

  • @yeseniagarcia9274
    @yeseniagarcia9274 3 роки тому

    How did you pass your smog check?

  • @KoryRude
    @KoryRude Рік тому +1

    Code problems point to circuit problem not necessarily sensor problem..sensors do go bad butt
    Butt.....dirty engine...or. Less maintained engines or wear good mileage engines....cause
    Multiple problems...by tightening up...specifications.....flow of pressures is monitored by computer....resetting codes after copying to record......maintains your record but resets limo mode..or what is known as reduced power mode....when YOU thinj it's a serious mechanical problem which is actually a small leak.
    The emissions controlled state of dealers n manufacturers and engine users.....want you to FIXX.

  • @KoryRude
    @KoryRude Рік тому

    The sensors or emissions control system should directly help DIY to identify failed parts and circuit
    But it's designed to HELP....using CODES.
    Never let government help...
    Because it's a
    Racket.
    When in fact they could a designed sensors to isolate the exact part or parts or problem so
    WE always know.

  • @abh1945
    @abh1945 3 роки тому

    I have Cooper S r56 when I start the car in morning it rough for 20 to 30 seconds and I have check engine I replaced spark plugs and 2 coils (cylinder 1,2 ) because I have misfiring in these cylinders but I didn’t replaced injectors and I didn’t check the O2 sensor. Do you think the problem with O2 sensor or something else?
    Thank you

    • @gompro4943
      @gompro4943  3 роки тому +3

      I had a misfire in 1 cylinder and after replacing all four plugs no misfire warning came on. Regarding rough idle, it can be a separate if you still experience. It can be rather complex, but I would start with oil change, O2 sensor, and if still happens I will look for the air intake. The first two should not be too difficult or expensive.

    • @abh1945
      @abh1945 3 роки тому

      @@gompro4943 thank you and should I Diagnose the timing chain because I took a video when I started the car (cold start) and a lot of people said I should check the timing chain immediately! what do you think?

  • @KoryRude
    @KoryRude Рік тому

    Think....think.....that's why deficit.....keeps goin up...n up....
    And
    Weezer in debtor prison.