Hi, The TMAX manual says more easy way. Does it not work? "V-BELT REPLACEMENT The V-belt on the TMax can be replaced by taking off: - Right middle side panel - Right floorboard - Small shroud - Rear passenger footpeg - Muffler stay bolt - Plastic cover from V-belt transmission cover. Move the fuel filter and pump out of the way. Remove the V-belt transmission cover while moving the muffler out of the way. Install two 45 x 6 mm bolts into the threaded holes of the secondary sheave. Tighten the bolts evenly until the secondary sheave is spread apart far enough so that the V-belt can beremoved. Install the new belt and remove the bolts. To reset the V-belt indicator light, disconnect the 2-pin jumper connector for 2 to 5 seconds with themain switch turned on, then reconnect it."
Hi,
The TMAX manual says more easy way.
Does it not work?
"V-BELT REPLACEMENT
The V-belt on the TMax can be replaced by taking off:
- Right middle side panel
- Right floorboard
- Small shroud
- Rear passenger footpeg
- Muffler stay bolt
- Plastic cover from V-belt transmission cover.
Move the fuel filter and pump out of the way.
Remove the V-belt transmission cover while moving the muffler out of the way.
Install two 45 x 6 mm bolts into the threaded holes of the secondary sheave.
Tighten the bolts evenly until the secondary sheave is spread apart far enough so that the V-belt can beremoved.
Install the new belt and remove the bolts.
To reset the V-belt indicator light, disconnect the 2-pin jumper connector for 2 to 5 seconds with themain switch turned on, then reconnect it."
Should you use a sheave tool and torque wrench during installation? Thx
Il variatore va stretto con una chiave Dinamometrica
la dinamometrica???
ma si può stringere un variatore con la pistola ad aria????
🤦
Evidentemente non conosci pistole pneumatiche dinamometriche🤷🏽♂️🤷🏽♂️
@@ycgarage5750 si infatti, sono precisissime🤦