2009 Dodge Charger 3.5l Crankshaft Position Sensor Replacement

Поділитися
Вставка
  • Опубліковано 7 вер 2024
  • Here i give a general description on how to remove and replace a crankshaft position sensor on a 2009 Dodge Charger SXT with the 3.5l v6. I wll slowly start uploading videos similar to this with the Charger so Like Comment and Subscribe. Also let me know what else you want to see with the Charger I recently got this car back in March and I’m going to be uploading vehicles showing my process on how I’m going to make it my own.

КОМЕНТАРІ • 17

  • @TheblackoCato
    @TheblackoCato Рік тому +1

    Broooooo. Good video. With your help I managed to finish before the sun went down

  • @bryantross3532
    @bryantross3532 8 місяців тому

    Short. Sweet. Specific. Thanks man!!!

  • @winterbreeze9860
    @winterbreeze9860 2 роки тому +3

    Best video, I have seen

  • @rigojohn2032
    @rigojohn2032 Рік тому

    THANK YOU! YOU JUST SAVED MY DAY

  • @danielbochette2702
    @danielbochette2702 2 роки тому +1

    Gonna replace mine tomorrow. Fingers crossed it works.

  • @chrisperez2503
    @chrisperez2503 2 роки тому +1

    What brand was the replacement?

  • @shawnjones2928
    @shawnjones2928 2 роки тому

    Did you get code when it went out?

    • @KompleteKustoms
      @KompleteKustoms  2 роки тому +1

      Yes it threw a code and went into limp mode had to drive about 20min with it in limp mode until i got to AZ n got the part n a simple turn off and restart n limping it home under light throttle got me home without issue

  • @RENEHERNANDEZ1986
    @RENEHERNANDEZ1986 3 роки тому +1

    Isn't that the cam shaft sensor?

    • @KompleteKustoms
      @KompleteKustoms  3 роки тому +4

      To my knowledge the camshaft position sensor is located on the top of the engine drivers side head area pointed towards the passenger side. When i replaced this it threw codes for a crank sensor i located that specific sensor replaced it and cleared the codes and they haven’t came back since. It is also the part that I grabbed at auto-zone.

    • @ethanallen2680
      @ethanallen2680 2 роки тому +1

      @@KompleteKustoms did you have to relearn the crankshaft sensor to the car?

    • @KompleteKustoms
      @KompleteKustoms  2 роки тому +1

      @@ethanallen2680 no for me it was a plug and play application, but I cannot confirm this to be true throughout all vehicles. Ive had this sensor in the car for over a year without any of the same symptoms returning.