How to Install the Delta® EverEdge Shower Wall Set (48x34)
Вставка
- Опубліковано 23 лип 2024
- Follow along as Mike and Hannah walk through how to install the Delta® EverEdge 48x34 Shower Wall Set. See our supply list and video shortcuts below to make installing even easier.
You'll Need:
- Drill
- Safety Glasses
- Caulk Gun
- Adhesive
-Two Tubes of Sealant
- Tape Measure
- Staple Gun
- Sill Plate Gasket
- Level
- Carpenters Square
- Shims
- Drop Cloth
- Pencil
- Utility Knife
- 3/16” Drill Bit
- Bit Holder Extension
- Driver Bit
- 1 ¼" Stainless or Zinc Plated Truss Head Screws
- Hole Saw
- 2 ½” Construction Screws
- Lumber
Steps:
0:00 Intro
2:43 Check for Plumb, Square, & Level
3:44 Install Blocking
5:28 Install Door Nailers
7:13 Dry Fit Panels
9:10 Drill Pilot Holes
14:10 Install Foam Tape
16:24 Install Fire Retardant Pad
17:37 Install Back Panel
20:28 Install Side Panels
Check out these related videos:
How to Install Shims - • How to Install Shims
How to Install the Delta® EverEdge Shower Base (48x34) - • How to Install the Del... - Навчання та стиль
Do you use a moisture barrier on an exterior wall? And if so, do you still use the sill plate gasket & adhesive?
How do the screw cover up
I didn’t catch if you used any adhesive on the side panels?
It seems as though I have a gap where the corners meet. Should there be space there? I've taken my panels down a dozen times to refit them and both corners have a gap. Ugh. This is day 3 I stead of hour 3 of working with these panels. Uber frustrated. Any advice?
What did you end up doing? I have the same gap!!! It's just not clicking in no matter what I do
Same here need any advice I could get.@@davidtinney9463
@@davidtinney9463 I HAVE THE SAME THING! almost a one-inch gap in the middle of the back corners top and bottom are closed tight but center has a bigger space and no click sound to lock in? what did you do?
@@mikemazzoli1990so I shimmed out the wall behind it to help seal in those areas and beat the living hell out of it until it fit. It hasn’t leaked yet and it’s had regular use for a few months
How much room do you need to allow for the door nailers from the base plate- how tall is the flange?? Why the heck do you not tell us that???????????????????????
jazz hands at 9 minutes
Nothing clicked in for me… I didn’t have notches to click
Pretty sure that’s not a 48” pan
Really wish they didn't gloss over the details...