With a decently built 400 trans, coupled with a NP 203 transfer case, 4.56 geared front Dana 60, and a 14 bolt Detroit locked full floater rear, turning those 44's... it'll do that all day, EVERYDAY !!! 😀🤗🙂
@@optimusprimer4392 Exactly... Back on my 78 Chevy I ran 38's with Just a sb 350, buttt I put a blower on top, into JUST a TH 350 to a New Process ( I called em NO PROBLEM 203) to 4.56 Detroit rear, and Dana 60 front 👌 I'd spin those 38's thru mud and snow with ease (NOT quite that size pit in this video) but deep mud, ruts & snow EASILY & sometimes JUST in 2wd. My truck would run through anything when I'd put it in 4wd 😋 NEVER had a problem, AND DIDN'T get stuck.
finally, someone in a mud hole smart enough to understand that you CAN OVER SPIN THE TIRES. To much wheel spin and you have less traction than to little. Pump the throttle just enough to clean the tires. Awesome job.
That's just bad ass! 🇺🇸👍🏽 nice truck! If I was next in line I would of been like holy shit! Lol. Im glad the guy with the rifle didn't slipped and fell underneath that tire.
That's a chevy. Like rock. They don't make them like that anymore. I got a 72 k20 3/4. Locking hubs. 72 s and square body's. Bad trucks. Awesome job. Not giving up.
Guessing it needs some 60 inch tractor tires would of been way easier, but hey been there done that with 78 blazer 350 auto, 35 inch tires except before I knew about high rise breather tubes front and rear differential then and ruined them with water haha lol!
Duh... the joke is that he was bottoming out on the axles and then he dug giant ruts with his spinning tires. So..........the next guy in line is going to have a tough time, unless his truck has more clearance at the axles, in which can be achieved with larger diameter tires. Thus....my comment for the next guy needing bigger/ taller tires. Ugh 😑
These people in the comments are clueless. No he didn’t make impassable if you had 35s before. This was already tore up, in fact he cut the center section down a bit. Last guy probably had tractor tires
Legend has it That's his driveway..
With a decently built 400 trans, coupled with a NP 203 transfer case, 4.56 geared front Dana 60, and a 14 bolt Detroit locked full floater rear, turning those 44's... it'll do that all day, EVERYDAY !!! 😀🤗🙂
I've got the same set up love it...
People bash on the 203 I run a 400 small block with an sm465 and a np203
@@optimusprimer4392 Exactly... Back on my 78 Chevy I ran 38's with Just a sb 350, buttt I put a blower on top, into JUST a TH 350 to a New Process ( I called em NO PROBLEM 203) to 4.56 Detroit rear, and Dana 60 front 👌 I'd spin those 38's thru mud and snow with ease (NOT quite that size pit in this video) but deep mud, ruts & snow EASILY & sometimes JUST in 2wd. My truck would run through anything when I'd put it in 4wd 😋 NEVER had a problem, AND DIDN'T get stuck.
Square Body Chevy Greatest Truck of ALL TIME PERIOD !!
That limited slip front locker killing it going forward, still a beast, love it, thanks for posting
A limited slip and a locker are 2 different types of differentials.
Now that's old school 4wheeling there!!
Oh god! I miss My lifted Chevy blazer I had back in the days 😢
Nice mudride there! 💪👍
When things get heavy, breakout the Chevy!
Thats the quickest way to turn the transmission into a stove.
Nah man, that’s that new liquid cooled turbo 400 tranmission
If u build a truck like that I can handle it😁
Getting plenty cooled...watered down
Y’all dumb if you think the transmission and transfer case isn’t burnt out of this POS lmao
@@timothycasteel8681 transfer cases burn out?
Awesome truck & one hell of a driver. I am am a Ford/ Dodge man but kick ass is kick ass
Hell yeah bro, never give up. Nice pull through the hole brother and wasn’t to sure at first but came through
Now that’s someone that understands you ain’t stuck till you quit movin
Now we got the mall crawling, old school 4x4 and the way we did it love it!
finally, someone in a mud hole smart enough to understand that you CAN OVER SPIN THE TIRES. To much wheel spin and you have less traction than to little. Pump the throttle just enough to clean the tires. Awesome job.
That's just bad ass! 🇺🇸👍🏽 nice truck! If I was next in line I would of been like holy shit! Lol. Im glad the guy with the rifle didn't slipped and fell underneath that tire.
Could have sworn I was listening to a Ford power steering pump lol. BA truck though for sure! Love a Square body
That’s that stank mud. I can smell it from here!
Lmao that's what I was thinking
That's some deep ass stank mud!
Nah your just taking a shit while watching this
We call it baby shit mud out in Western PA, 😂
Nope that's your feet😂😂
I'd love to be the one driving that beast
What a beast. Chevy power all the way
Sounds like it’s got a ford power steering pump.
Probably gear drive timing set
Maybe a small blower?
How about a transmission on its way outt !!!!!
@@TheRoadhammer379 no
@@fastfordman1965 no
Damn!!! Thanks for making it impassable for everyone else
A lot of people would have got out the tow rope but this truck had a lot to go
I dont grab a tow rope till i cant move
What a beast. AWESOME
Insane brother wicked truck
Tell me how every inch of that truck was covered by mud but the license plate was still clean
State laws say your license has to be free from obstructions he's just following the law like a fine upstanding citizen lol
Most likely ceramic coated
Pam
That was awesome!!!!
That's What I Call draining the swamp.
Thought this truck was 2wd at first then i saw how massive this hole was
THAT WAS AWESOME!
Hell it has a hard bottom! Ruts are too deep doesn't matter how big of tires you got if it doesn't have ground clearance.
Tires give you ground clearance . Dip stick
Transfercase sounds bit noisey but that is beast bad ass truck
Gear driven t case are noisy as hell. I had this same T case. In my 79 ramcharger. I will take a gear driven Tcase over the chain driven ones
@@keithlea6804 oh ok that's why gear to gear and not chain never give that a thought that's Awsome that's when trucks were trucks!
@@keithlea6804 in pretty sure it was an old BW1356 that was my step Dad's old Ford. It made a whine similar.
This video made me think of the Jawga Boy's "Rollin Like A Redneck" its a Country Rap Song
Not a monster truck but that truck is a monster! Good run!
That debris had me nervous during his final tried
Nice job, I used to reverse through holes like that, you’d be surprised
GO'S TO SHOW,
KEEP EM MOVEN AND KEEP ON GOIN. 🚗
Bad ass truck .
Wicked mud pit! Has anyone made it through on the first pass? Nice old Chevy
Dam does that bring back memories
👍🏾for the truck
Awesome job!!
That's a chevy. Like rock. They don't make them like that anymore. I got a 72 k20 3/4. Locking hubs. 72 s and square body's. Bad trucks. Awesome job. Not giving up.
Todd Kaperak , first year of the square body is 73 , the 67 to 72 all had round front clip , I have both
Chevy like a rock
bad ass Chevy they never stop f***** BEAST!
Now that’s impressive
Truck sounds crazy
Jarves Root it’s probably got a timing gear drive set rather than a chain
Guessing it needs some 60 inch tractor tires would of been way easier, but hey been there done that with 78 blazer 350 auto, 35 inch tires except before I knew about high rise breather tubes front and rear differential then and ruined them with water haha lol!
A, hell yeah brother, seems appropriate
Badass truck
That, my friends, is how you burn a whole tank of fuel.
Worth it!
Some places a four wheel drive will get stuck that's why is good to have a winch on the front to pull it self out
Looks like the next guy better have a bigger tire than 44s
Duh... the joke is that he was bottoming out on the axles and then he dug giant ruts with his spinning tires. So..........the next guy in line is going to have a tough time, unless his truck has more clearance at the axles, in which can be achieved with larger diameter tires. Thus....my comment for the next guy needing bigger/ taller tires. Ugh 😑
This should be called cutting a new rut. I sure didn't think he would make it thru that mud hole!!
That blowing some gravy
Chevy 👍👍🤟💯
Fight til the end beautiful rig Dana 60s? I had a 75 headlights look like dead fish at night covered in mud like that
wow.. love that truck... making the way for all the others !!!!
Such an aggressive pull up
Still movin. Hammer down
Man I hope I dont run across any mud holes he has been thru. My 33s would be gobbled up!
Whoosh almost got stuck there 😂
Looks like either grey county boys or Simcoe county boys 🤘
Chevy fucking power
Holy shit that swallowed those 44s Quick
Experienced driver nice work
Looks like a Tennessee smith mountain mud hole
#SWAMP DONKEY! mad props!
The big Chevy got it done!
A big hell yeah...
One bad ass bowtie 🤘🤘🤘
Goddamn boy, skin it back and let the gnats hit the bumper!
Took a min, but ol boy drained that pond. could see where he was goin
Now that’s how you do it
Gotta crawl before you walk!
Hell yea Nice !!!
Damn, right it’s a Chevy
Bad ass Chevy right there period!
Great video. Truck is a beast.
Badass man🤘🤘🤘
Yup, fuck it up for all the trucks behind you.
Chevy time!
Sheeesh da powa 🌟🌟🌟🌟🌟
Look like Ontario plates on that truck
Sweet!
✌
Your God Damn Right
These people in the comments are clueless. No he didn’t make impassable if you had 35s before. This was already tore up, in fact he cut the center section down a bit. Last guy probably had tractor tires
Talk about blazing a trail...
dam , no mud left for the next guy
That truck is a fuckin animal !!!!! Wow
Keep truck moving that's the key
Freakin rootin baby
Was that marksman with the rifle carrying it by the scope.Hmmm . Bet it's pretty accurate.
The poor guy that try’s that hole on 35s after this pass.
Fu**ing brutal.
It's been a bad day if it comes home clean
Who's here after whistlin diesel drove into the water
Love the canadian carwash
Sounds like a 4 banger
I know that. Just saying I had a 72. And the chevy square bodied are awesome chevys . just making a comment .
Not scared to use it !!😜
Sounds under powered