Sounds like it’s running at half throttle it should be screaming! Trimmed how it should be you wouldn’t be able to run it wide open for that amount of time it wouldve shut down from overheating.
It's running the same speed with both stock remote and the dx5. 40mph is all I can get unless something needs to be programmed in the esc. Or maybe raise the trim tabs some. Temps was always low after each run. Very strange being I haven't done nothing from out of the box.
@@nwirc that’s correct. Basically take your Allen key and turn it a quarter turn by looking at it and then tighten the screw and then go to the other tab and turn it just a quarter turn open that way they’re done evenly and you’re not just guessing.
With a hydra esc and prop change, getting mid 50’s but temp on motor gets pretty warm, usually around 140 after a run
@@VetteWay2Fast Awesome that will be one of my first upgrades besides trying different props.
Sounds like it’s running at half throttle it should be screaming!
Trimmed how it should be you wouldn’t be able to run it wide open for that amount of time it wouldve shut down from overheating.
It's running the same speed with both stock remote and the dx5. 40mph is all I can get unless something needs to be programmed in the esc. Or maybe raise the trim tabs some. Temps was always low after each run. Very strange being I haven't done nothing from out of the box.
Yea mine didn’t do much more than low 40’s out of the box. Even running fairly dry. Imo this boat for its size needs to be at least 10s
@@VetteWay2Fast Agreed 100% 10-12s for sure. I'm going to run mine a little dry and see what she does before I start upgrading.
lift the tabs up a smidge and you'll see a difference in speed
So run it a smidge dryer.. I'm out of lipo option with the 3 diff brands I used so far. I will give that a shot! Thanks for the info.
@@nwirc that’s correct. Basically take your Allen key and turn it a quarter turn by looking at it and then tighten the screw and then go to the other tab and turn it just a quarter turn open that way they’re done evenly and you’re not just guessing.
@Mindcoach1on1 I have a straight edge I can use to be precise but I will do this tune in my next video. Do you mind if I give you a shout out?
@@nwirc You can give m&m dynamics UA-cam channel the shout out as I’ve learned everything from them. 😀😀😀
I don't think you have your throttle turned up all of the way to 150 percent
It's at 100 on the Dx5.. You say 150 will do the trick?