How To Replace A Hub & Wheel Seal on a 4WD Case IH (Part 3)

Part 3: Filthy Rich shows you how to replace a hub seal on a 7140 Case IH tractor! More Tractor Videos: • Tractor Vids
00:06 Wheel Hub Bushing Removal
00:50 Wheel Seal Removal
01:27 Wheel Seal Replacement
02:23 Wheel Seal Press Tool
Never forget another measurement. tapeboss.com
Support us on Patreon. / debossgarage
Get some merch. shop.spreadshirt.com/debossga...
Follow Rich on Twitter. / debossgarage
Follow Rich on Instagram. / debossgarage
Follow Rich on Facebook. / debossgarage
Follow Rich on Car Throttle. www.carthrottle.com/user/debo...
*If the video was helpful, please give it a "thumbs up" and consider subscribing.*
WASSUP I'm In A Plane!
• WASSUP I'm In A Plane!
DAMN HEADLIGHTS: '52 Studebaker 2R6 Magnum 360 (Part 6)
• DAMN HEADLIGHTS: 360 M...
"Travelin'" by SWIB ( / swib-1 ) CC BY-SA 3.0
NO WARRANTIES: All of the information provided in this video is provided "AS-IS" and with NO WARRANTIES. No express or implied warranties of any type, including for example implied warranties of merchantability or fitness for a particular purpose, are made with respect to the information, or any use of the information, in this video. DEBOSS GARAGE ("DG") makes no representations and extends no warranties of any type as to the accuracy or completeness of any information or content of this video.
DISCLAIMER OF LIABILITY: DG specifically DISCLAIMS LIABILITY FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES and assumes no responsibility or liability for any loss or damage suffered by any person as a result of the use or misuse of any of the information or content in this video. DG recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. DG assumes or undertakes NO LIABILITY for any loss or damage suffered as a result of the use, misuse or reliance on the information and content of this video.
USE AT YOUR OWN RISK: This video is for informational purposes only. It is your responsibility to evaluate your own safety and physical condition, or that of your clients, and to independently determine whether to perform, use or adapt any of the information or content in this video. Any automotive repair and/or modification may result in injury. By voluntarily undertaking any task displayed in this video, you assume the risk of any resulting injury; your safety is the sole responsibility of the user and not DG.

[@canadacatalyst]

here we go!

[@aserta]

You don't need to find something big. You can use small pieces of stock placed along the line. I use this trick all the time. You just stack them as high as you need around the o-ring/seal/bearing and then put your plate on top, and voila you're done.
My recommendation: get used gauge blocks. That way you'll have equal height all along, but flat stock works just as fine as long as you deburr the edges.

[@DEBOSSGARAGE]

Thanks for the tip!

[@michaelcockburne9857]

What is the part number for that seal

[@abigailpeterman173]

we are replacing the seals bearing in the hub, any help in regards to getting the stub to snap into the ring inside the yolk. ?

[@nates90]

I'm replacing the seal behind the sun shaft bushing, I'm also putting in new bushing but the sun shaft still has a little wobble in the bushing....is this correct? Thanks

[@munirladha6787]

The tension spring behind the seal looks like it is out 3:36, I may be wrong.

[@chenderson4969]

It’s a 2 piece seal