4 Watchouts to Prevent Future Headaches on Maintaining Your Older Audi R8

Поділитися
Вставка
  • Опубліковано 27 лип 2024
  • There are some things you just stumble upon when maintaining a decade old car. Take this advice when you're researching on buying an older R8 (Gen 1) or you want to get ahead of potential issues if you're a current Audi R8 owner.
    Support:
    How to support me? Buy Me a Coffee. Every little bit helps as I build more cool stuff to share with you: www.buymeacoffee.com/ftwgarage
    00:00 Intro
    00:45 Release Cords
    03:55 Oil Filter Housing
    04:22 Rust
    06:00 Rivet Nuts
    Music Credits:
    ------------------------------
    Chill Guitar / Flamingo by Lesion X / lesionxbeats
    Creative Commons - Attribution 3.0 Unported - CC BY 3.0
    Free Download / Stream: bit.ly/flamingo-lesion-x
    Music promoted by Audio Library • Chill Guitar / Flaming...
    Autumn 2011 by Loxbeats spoti.fi/34tPBBO
    Creative Commons - Attribution 3.0 Unported - CC BY 3.0
    Free Download / Stream: bit.ly/autumn-2011
    Music promoted by Audio Library • Autumn 2011 - Loxbeats...
    ------------------------------
  • Авто та транспорт

КОМЕНТАРІ • 11

  • @nornibres
    @nornibres 8 місяців тому +1

    Excellent video of issues I haven't seen before. Too bad Porsche didn't put the manual hood release in a convenient location like Audi did.

  • @rajpatel3513
    @rajpatel3513 Рік тому +2

    Thank you for the tips 👍

  • @villaman4818
    @villaman4818 Рік тому

    Thank you 🙏

  • @unvaccinatedguy5378
    @unvaccinatedguy5378 7 місяців тому

    You do not need to open frunk to jump start. Cigarette lighter port will jump just fine.

  • @jimf5160
    @jimf5160 Рік тому +2

    FYI, WD40 is a solvent, not a lubricant... WD 40 does make lubricants...use those instead. Very good tips otherwise. My Porsche 997.2 also has a similar frunk release. When I store the car, I always leave the frunk ajar, in case my battery tender fails and my battery runs down.

    • @ftwgarage
      @ftwgarage  Рік тому +1

      Thanks for the WD 40 correction! Looks like I’ll need to get a specific wd40 lubricant

  • @TheConorMLife
    @TheConorMLife Рік тому

    I believe my gas cap pulley is broken. Went to pull it, pulled it, and nothing.

  • @dannymerchant7353
    @dannymerchant7353 Рік тому

    I Have a question when you get that message gearbox malfunction where's that sensor located it show on my audi one time never saw it again

    • @ftwgarage
      @ftwgarage  Рік тому

      Hey Danny, I recommend you pull the OBDII code to figure out what's throwing that code.