I'm not getting the sounds you are mentioning but I'm trying to find what is. I don't hear clicking or sounds while accel or turning. But over bumps, tiny bumps. and its a RATTLE RATTLE, like literally something is loose but when I look under, I don't see anything, I can only shake so hard with my hands so probably I'm not putting enough load on suspension parts to find out what it is. I looked at sway bar endlinks, or maybe bushings.
Yikes! You didnt set the axle nut by dinging the edge, as you were supposed to! This is ... Kinda important! And where did you get this info on tightening shock fork bolt on ground? Also, why tork this last bolt properly, when you didnt bother with others?
great video very informative and helpful axle joint replacement nice work keep vlogging i'm here sending full package gifts thank you and stay safe
Awesome thank you!
My outer Knuckle on my cv axel was what broke and I thought it was my wheel bearing but this helped a lot thank you 😊
You're welcome! Tnx
Nood lang hehhehe good luck po and god bless
Nice video, super helpful. Dang you reeeeally took a lot apart to get it swapped though.
Awesome video. Covered everything 👍🏽👍🏽
Thank you! If both wheels were raised I didnt have to release the stabilizer link rod nut for it is under tension.
thank you for sharing your knowledge to replace axle joint i'm new friend here complete support hope to see you in my small house enjoy vlogging
thanks, sure thing. C ya
@@newarkstudios1137 thank you
Thanks for the great video! Where did you pick up that axle? Thanks
I'm not getting the sounds you are mentioning but I'm trying to find what is. I don't hear clicking or sounds while accel or turning. But over bumps, tiny bumps. and its a RATTLE RATTLE, like literally something is loose but when I look under, I don't see anything, I can only shake so hard with my hands so probably I'm not putting enough load on suspension parts to find out what it is. I looked at sway bar endlinks, or maybe bushings.
What is the right position of bearing? Top or bottom?
The axle bearing was not affected in the procedure
lol, That axle nut was easy huh? Sometimes thats the hardest part of wirking on a Honda
Thanks, this was really helpful. Is that a manual transmission?
Its A/T yes. If both wheels were raised I didnt have to release the stabilizer link
Are you shows is difficulties
What size Is the nut of the axle un the Center of the wheel
36mm
ABS ring
Would be nice to know what millimeters to use
36mm axle nut socket
17mm for shock fork / castle bolt IIRC
Yikes! You didnt set the axle nut by dinging the edge, as you were supposed to! This is ... Kinda important!
And where did you get this info on tightening shock fork bolt on ground?
Also, why tork this last bolt properly, when you didnt bother with others?