I had this same 95 error code, units stopped at 2am and this popped up. I powered down, took off the panel and looked at all wiring and the pcb and it was ll clean and intact, actually all looked brand new. The only other thing i did was I pressed the "Check" button on the pcb, which does a wiring check I believe. After it completed, i reset power again. And all are working. Leaving this here if it helps anyone. Any idea why this worked or what could have gone wrong? There was a Brownout warning in my area yesterday, maybe some sort of variance in the supply caused it ?
@@joeny1980 how did you get on with your error 95 fault? I have same problem and wiring to compressor seems fine as is the resistance which is 0.9ohm between any of the 3 wires. Where is the check button and did it help pressing that again?
How many amber blinks do you get? How many green blinks do you get? Then after you count the blinks, google “Fujitsu error codes”and find the blinks you are getting to help you diagnose
Looking cold up there hope you are staying warm and dry. Another good service call Paul.
Thanks Hugh. I appreciate. And it is getting cold for sure
Inverter and eco motors are 3 phase wound motors that's why you should get the the same reading to each winding.
I have same fault but the connections on top of the comp look fine
-
I had this same 95 error code, units stopped at 2am and this popped up. I powered down, took off the panel and looked at all wiring and the pcb and it was ll clean and intact, actually all looked brand new. The only other thing i did was I pressed the "Check" button on the pcb, which does a wiring check I believe. After it completed, i reset power again. And all are working. Leaving this here if it helps anyone. Any idea why this worked or what could have gone wrong? There was a Brownout warning in my area yesterday, maybe some sort of variance in the supply caused it ?
...I spoke too soon, problem came back in less than a day
@@joeny1980 how did you get on with your error 95 fault? I have same problem and wiring to compressor seems fine as is the resistance which is 0.9ohm between any of the 3 wires. Where is the check button and did it help pressing that again?
@@lookoutleo check button is on the PCB board. Nothing helped, the problem came back. I'm actually currently waiting for a warranty replacement
@@joeny1980 what warranty does it have?
@joeny1980 comprsssor fan motor and boards could be shot. Thanks for the comments.
Cool mode only compressor running 1 minute but blower motor not running..
Is that a question?
How many amber blinks do you get? How many green blinks do you get? Then after you count the blinks, google “Fujitsu error codes”and find the blinks you are getting to help you diagnose
Looks like a cannabis grow
Snow day tomorrow
I wish.