This one of the reasons I bought a new tent. I’m thinking of supergluing Velcro on the outside inner and inner outside near the rope hole. Tried crocodile clips and one little bit of wind and it came loose.
Nice idea and great video! Thanks 😊 I’ve done a few bits to mine which help. The best one being I think, 3mm bungee cord on the guy out and door peg points to help take the slack out of the outer. I also put some pockets on the side walls and I think your mod will really help stop the sides sagging in when the pockets are loaded. I think the standard zippers tags need replacing too.
I pulled the inner about halfway along the toggle strap, I found that to be the perfect balance between pulling the inner tighter without misshaping the inner 👍 used e6000 glue and doubled up thread
reinforce the corners of the bathtub (you could 3D print something and glue it into the 4 corners, or use 4 twister bits of wire (folded over at the ends, one 1cm twister right, the other end twisted left and glue/sow into the corners, maybe make a little pocket for it?
Nice. It would have been good if they'd joined the sides to the inner with a spacer so that pulling the outer out pulls the inner out too. Which Lanshan are you referring to in the video?
This one of the reasons I bought a new tent. I’m thinking of supergluing Velcro on the outside inner and inner outside near the rope hole. Tried crocodile clips and one little bit of wind and it came loose.
Nice idea and great video! Thanks 😊 I’ve done a few bits to mine which help. The best one being I think, 3mm bungee cord on the guy out and door peg points to help take the slack out of the outer. I also put some pockets on the side walls and I think your mod will really help stop the sides sagging in when the pockets are loaded. I think the standard zippers tags need replacing too.
I pulled the inner about halfway along the toggle strap, I found that to be the perfect balance between pulling the inner tighter without misshaping the inner 👍 used e6000 glue and doubled up thread
Brilliant and simple solution, I'll be giving this a go too. Thanks for sharing.
Hope it helps mate... let me know what you think afterwards always interesting to hear other people's opinions
reinforce the corners of the bathtub (you could 3D print something and glue it into the 4 corners, or use 4 twister bits of wire (folded over at the ends, one 1cm twister right, the other end twisted left and glue/sow into the corners, maybe make a little pocket for it?
Nice. It would have been good if they'd joined the sides to the inner with a spacer so that pulling the outer out pulls the inner out too. Which Lanshan are you referring to in the video?
hi
it's the 3ful zastrugi 2
I’ve thought of that too and had considered a mod. I think there’s a risk that condensation or moisture would travel along and soak in to the inner
What glue and thread did you use? Thanks!
I just used super glue and normal cotton thread nothing special