IGNITION WIRES - How to protect them from heat!

Worlds Cutest Frog How to protect your ignition wires from hot exhaust headers and manifolds using fiberglass insulating boots and wire sleeves..no more burned wire boots!!

[@buzztrucker]

You ALWAYS got to put a lil' grease when you enter the hole. Agreed!

[@klowny1969]

buzztrucker lol yes!!

[@truemanrep3267]

if your good looking the hole is already wet

[@jaxv94]

the Fonz? AAAAYYYY!!!!

[@klowny1969]

Xiuhcoatl ayyyoo

[@LegendaryWoke]

Yeah you don't want them right on the headers... those boots will burn a bit still although much less than without the boots

[@benkalinowski5834]

Hey
I have a 88 GTA
And I'm doing a 383 swap with a t56
Do you have a video on how to do the clutch master and slave swap
I tried to use the master and slave that came with my 95 swap and the bolts were diff
So I need to use my t5 master t56 stainless line and my t56 slave
Is there anything tricky I need to know

[@johnhern2994]

I bought the boots I bought the sleeves. Waist of time and money. 454 ci gm.

[@sumeetsandhu2196]

I tried putting on the sleeve but its still burning , sleeve starts to burn right after i turn on the engine and starts to give some smoke

[@klowny1969]

It will stop burning after a while..it's just the oils burning off

[@AK-ic1yj]

I have those boots and if they lay on the header the wires get mega burnt up. Don’t ever do that!

[@danhenry4162]

The same thing happened to me too.

[@apkr4501]

What is that yellow part u said? Will I get it in hardware store in india

[@klowny1969]

Probably not

[@jerryjames9845]

they that work burnt right through and got my leads anyway