I've been installing them for over 20 years. The only nut I tighten with a tool is the nut on the stop valve. I've seen these plastic nuts crack and flood homes so hand tighten and let the rubber do the work.
Nice when everything seized on and takes you 2 hours to get all he nuts off, the blood sweat and tears isn’t worth it 😂 that’s why I’d rather pay someone to do it, it’s not as easy as it looks in this vid believe me and I’d use ptf tape too, pay £80 to get it done or suffer I know which I’d choose 😂
I thank u so much,this is the first time that I install a fluid master..I didn’t need NO tools 🧰 🛠️ you are allot of help..i do appreciate you and you posting this video to help others like me.. thank you once again...😊many blessings
Hay smart guy make sure you adjust the height of the fluid master so it’s high enough to be able to flush toilet and don’t have too high if and whenever if the washer goes bad and it keeps running and water runs out of the whole of the trip lever
I've been installing them for over 20 years. The only nut I tighten with a tool is the nut on the stop valve. I've seen these plastic nuts crack and flood homes so hand tighten and let the rubber do the work.
Talked a little to fast
Never use a pair of channel locks and a plastic supply line nut! And you will crack it and be in a world of trouble!
Or just spray it in the bowl instead of a bucket
Next time replaced the toilet supply line
Man if only there was an easier, cleaner way to drain the water in the toilet tank! Something that could be done with a finger...
Nice when everything seized on and takes you 2 hours to get all he nuts off, the blood sweat and tears isn’t worth it 😂 that’s why I’d rather pay someone to do it, it’s not as easy as it looks in this vid believe me and I’d use ptf tape too, pay £80 to get it done or suffer I know which I’d choose 😂
“We don’t need that”…..very sad
Turn off the supply valve, and then flush the toilet before taking out the old fill valve. Way less water will be in the toilets tank.
Never use the same water supply. Always change the water suppy. Its like $8 and not worth the risk. The plastic nut on the supplies weakens over time.
Fantastic job of not wasting minutes and minutes blurring away! Thank you comments for cautioning against using tools on plastic.
I thank u so much,this is the first time that I install a fluid master..I didn’t need NO tools 🧰 🛠️ you are allot of help..i do appreciate you and you posting this video to help others like me.. thank you once again...😊many blessings
I'm not a plumber even a little bit, but your video helped me get the job done. Thank you, sir, and keep up the great content and education efforts.
Thank you
Thank you for the video. Good man
Lifesaver video! Your insights + little common sense helped save the day! BONUS, wife is happy🤣
Hay smart guy make sure you adjust the height of the fluid master so it’s high enough to be able to flush toilet and don’t have too high if and whenever if the washer goes bad and it keeps running and water runs out of the whole of the trip lever
Great job 😂😂😢
Appreciate it
Thanks for the super helpful video, I was able to replace my fill valve in just a few minutes 👍