12v Dewalt Battery in Harbor Freight Hercules 12v Tool
Вставка
- Опубліковано 7 вер 2024
- This video shows how to make a Dewalt 12v battery work with 12V Harbor Freight Hercules tool. Hercules 12V Polisher/Grinder.
I was encouraged to so by another video • 12v DeWALT Battery🔋 in...
Andrew Marietta, Great guy with a great channel, please Subscribe and Follow. (He did it on the Ratchet tool)
To clarify, the resistor used in this video was 1/4W 10k ohm. The 2watt did not work.
Tools Needed:
10 torx allen
wire cutter/Stripper
Solder pen/Solder
box knife
1/4w 10k ohm Resistor
www.amazon.com...
If you like this video, Please Subscribe and Follow, Thank you
Shugga
can you do that with a 20 volt
@@trinidadaguirre2757 you have to figure out the resistance of the battery.
can you do that with a milwaukee battery?
@myreviews4905 not sure what you are asking
@@shuggakaine9257 Can you put in a Milwaukee Tool battery in a Harbor Freight tool?12V Milwaukee to 12V Harbor Freight.
@@myreviews4905 i think they are physically different..
@@shuggakaine9257 ok thanks
I'm trying to get the hercules 20v radio to work with makita 18v battery.
I hooked up + - and the radio turns on but turn shut off I guess need a resistor?
Hey Steve, I'm not familiar with the Makita batt resistance. But you need to get a reading of both the radio and the batt. the batt resistance must match the radio. if not then a resistor is needed. this is usually the third pin on the Dewalt.
Same for the 20v?
Im not sure, i havent opened up a 20v tool, nor tested the resistance on the Battery pack.
This guy gave you the wrong information. The UA-camr ua-cam.com/video/HQTbTE3OZjg/v-deo.html used a 10K resistor in the ratchet modification not a 10 ohm as he mentioned.
10K OHM is what i used. if you take a reading you will see its not perfectly matched to the Batt. However it works. I tried 1/4 - to 2watt. only the 1/4 worked..
How do you measure resistance?
I just did mine and it Burt up the motor within a couple minutes. Not sure if I just had bad luck or what. Is yours still working? I did my two ratchets a year ago and have used them a lot.
Hi Jake, mine is working great. No issues. Did you use the 1/4Watt 10ohm resistor?
@@shuggakaine9257 yeah i did
I have the same pack of resistors as you do.
@@Chevyblazer88 Mine has been working fine for the past couple months, i use it without any overheating.. i use it constant for about 5mins then put it down, and so on.. How long do you keep it running? Perhaps i can do the same and see if my motor stops..
I didn’t even get to actually use it I was just playing around with it to see that it worked. It probably only had 2 minutes of run time together and maybe 20 seconds of continuous.