Розмір відео: 1280 X 720853 X 480640 X 360
Показувати елементи керування програвачем
Автоматичне відтворення
Автоповтор
I would have some type of bottom support and always do, brim something as support on the first layer.
Have you tried ABS or ASA filaments on this plate? Also, i found online that isopropyl alcohol does not remove finger oils, soap and water does. You can try that on the original plate and the prints will stick well again.
I have not. I have only used PLA and PLA+ in my printer.
WHat? IPA will definately remove oils before soap n water...
Hello, can you show me your cura profile? Thanks in advance!
I can do that. There are still alot of settings that I need to tinker with.
happy with that print? Dude...it needs a lot of tuning
sou do BRASIL, fez algum outro projeto?
Estou trabalhando em alguns agora. Estarei postando atualizações se for bem-sucedido.
Okay, I see now why you needed to replace your nozzle.
Some segments in the video are stamped not adjacent to each other
I tried to put everything in the video in order of the steps to perform rather then my trial and error.
Glue stick would of been easier
The buildtak layer was coming off of the bed. Glue sticks worked very well for me before that.
I would have some type of bottom support and always do, brim something as support on the first layer.
Have you tried ABS or ASA filaments on this plate? Also, i found online that isopropyl alcohol does not remove finger oils, soap and water does. You can try that on the original plate and the prints will stick well again.
I have not. I have only used PLA and PLA+ in my printer.
WHat? IPA will definately remove oils before soap n water...
Hello, can you show me your cura profile? Thanks in advance!
I can do that. There are still alot of settings that I need to tinker with.
happy with that print? Dude...it needs a lot of tuning
sou do BRASIL, fez algum outro projeto?
Estou trabalhando em alguns agora. Estarei postando atualizações se for bem-sucedido.
Okay, I see now why you needed to replace your nozzle.
Some segments in the video are stamped not adjacent to each other
I tried to put everything in the video in order of the steps to perform rather then my trial and error.
Glue stick would of been easier
The buildtak layer was coming off of the bed. Glue sticks worked very well for me before that.