@No-rh6zp . Turn on transmitter make sure your throttle is at dead center. Then hold the power on button on esc for 3sec then release it should be blinking that’s for neutral hit the power button once to set then pull full throttle while holding it hit the power button once that sets full throttle go full brake hit power button that sets brake when you release brake it should calibrate start blinking turn off esc and then back on and it’s set.
@@LBizzyRC it didn’t work I’m having a lot of issues like it does not stay set and when it decides to work and I turn it off I have to recalibrate it and it sometimes doesn’t work can you make a video please I can find any other videos
@@LBizzyRC that’s what’s up brotha appreciate the reply! Have you been able to get it out and rippin yet?! Just ordered the same setup can’t wait to get it in the micro b
looking perfect buggy and unboxing bro...looking most fun😍🤟
enjoy
what soldering station do you have?
@mostcailmerob . That’s a Schinciders I picked up from harbor freight.
great video bro
thh
@davidseychell . Thanks 🙏🏾 much appreciated 👊🏾💯
Can you make a video of calibrating the mini 28 esc I’m having difficulties
@No-rh6zp . Turn on transmitter make sure your throttle is at dead center. Then hold the power on button on esc for 3sec then release it should be blinking that’s for neutral hit the power button once to set then pull full throttle while holding it hit the power button once that sets full throttle go full brake hit power button that sets brake when you release brake it should calibrate start blinking turn off esc and then back on and it’s set.
@ ok thanks I will tell you if it works
@@LBizzyRC it didn’t work I’m having a lot of issues like it does not stay set and when it decides to work and I turn it off I have to recalibrate it and it sometimes doesn’t work can you make a video please I can find any other videos
@No-rh6zp . Hope it helps just unloaded a video
@@LBizzyRC ok thank you so much
What pinion did you use?
@TheRealStuntShady . That’s the stock pinion , I used a 5/64 drill bit to bore the pinion out for the motor shaft.
@@LBizzyRC that’s what’s up brotha appreciate the reply! Have you been able to get it out and rippin yet?! Just ordered the same setup can’t wait to get it in the micro b
@TheRealStuntShady . Nah haven’t been able to run it at my local, It’s bout an hr drive but running it in the living room it’s really smooth, 👊🏾💯
my friend fut the furitek motor is plug and play
what motor is that mate? can you put part number