2014 Yamaha Drive, Gas - Quit Running While Driving
Вставка
- Опубліковано 6 сер 2023
- Welcome to Kevin's Golf Carts UA-cam channel! We make how-to's, repair and vlog-style videos. Ocasionally, we will have a live stream to answer your questions.
My Site - www.kevinsgolfcarts.com
Affiliate Links: I earn a small commission when you use the links below. These links help support my channel without added cost.
Amazon Store - www.amazon.com/shop/kevinsgol...
Kofi - ko-fi.com/kevinsgolfcarts
PayPal - www.paypal.me/theburns/5
Mattress Insider - goo.gl/rhQLMj
TubeBuddy - bit.ly/2okVnXe
Square - squareup.com/i/KEVINSGOLF
Amazon Links:
Cat LED Flashlight: amzn.to/3s6exNI
DEWALT Grease Gun: amzn.to/3J10osa
DEWALT Goggles: amzn.to/3HnE6Ap
Nitrile Gloves: amzn.to/3ojvuTX
Welding Gloves: amzn.to/3gkguAA
Dremel Rotary Tool: amzn.to/32RlzgE
Gummout Carb Cleaner: amzn.to/3uhkkTn
Compression Tester: amzn.to/35DjMNb
Milwaukee 1/2" Drive Impact: amzn.to/3L1SuAB
Milwaukee M18 Batteries: amzn.to/3gh4NKS
Milwaukee M12 3/8" Ratchet: amzn.to/3AS0jnI
Milwaukee M12 12-Volt Battery: amzn.to/3olztPD
Milwaukee M12 Rivet Tool: amzn.to/3ARdEwz
Mr. Funnel AF3CB Fuel Filter: amzn.to/35EGmVH
Neiko Impact Socket Set: amzn.to/3L529Gi
Neiko LED Work Light: amzn.to/3IZ1g0h
The Ear Buddy Ear Plugs: amzn.to/3scQwVd
Tek Motion Ultrasonic Cleaner: amzn.to/34gSHz3
Voltec LED Light: amzn.to/3rlCFwv
Other Links:
Husky 30 Gallon Air Compressor - go.magik.ly/ml/kqd6/
Camera Gear:
GoPro HERO 10: amzn.to/3okKEbA
ProGrade Digital SD Card: amzn.to/3KZK9NL
ProGrade Digital SD Card Reader: amzn.to/34ig4Iu
JOBY GorillaPod Tripod & Ballhead: amzn.to/3J29Aw2
Manfrotto 496RC2 Ball Head: amzn.to/3HnYUaY
Panasonic Lumix 12-60mm Lens: amzn.to/3GmJTow
Panasonic Lumix 14-140mm Lens: amzn.to/3rmcFBa
Panasonic Lumix GH4: amzn.to/3KYJThQ
Panasonic Lumix GH5: amzn.to/3HrtHDB
Ravelli AVTP Tripod: amzn.to/3Hr3CES
Pixel Wireless Lavalier: amzn.to/3GpQBtE
15lbs Sandbag: amzn.to/3AVrGx3
CRAPHY Softbox: amzn.to/3oo87bF
Disclaimer:
Kevin's Golf Carts cannot guarantee against unauthorized modifications or improper use of this information. Kevin's Golf Carts assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Kevin's Golf Carts recommends safe practices when working with all tools, chemicals, lubricants, or any other tools or equipment seen or implied in this video. No information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not Kevin's Golf Carts. If you are uncomfortable with replicating the actions used in this video, seek the service of a qualified professional. - Авто та транспорт
Honestly is the key. Thank you I found it very interesting and helpful.
A few years ago I quit my job of being a dealership mechanic at Honda and went into a position that required me to work on small engines and a whole lot of janitorial machines. I work on just about anything. Watching your videos helped me out so much because of the many different golf carts we have coming in. I wanna thank you so much for helping me out! You also inspired me to start my own channel on the different machines I fix! Thanks a ton!!!
Thank you for sharing Kevin 😊
Hi Kev.... I am Darrell from Cambridge UK. I have been a subscriber to your videos for years. I love your tutorials on how to repair the golf carts/buggies (in the UK we call them buggies). I love your honesty when you cock up when doing a repair 😁. Most importantly is you always show the end result of a perfect repair. Thanks mate keep the videos comming ..... Darrell...
Hindsight is 20/20. Thanks for taking us along.
I didn’t see it either Kevin. Until you bumped it. You are definitely NOT STUPID! Thanks for your honesty anyway. Great job Kevin!
Nice work!
Thanks!
Kevin anxiously awaiting your next video. Could you maybe do a video on winter storage and how to protect golf carts to make them winterized? Thanks buddy have a good one.
Great suggestion!
Thanks!
I have a Yamaha drive not sure the year because it has a custom paint job, and rear seat with lights, otherwise stock. When in neutral if you put the petal in one spot with the key on it will not stop surging, I know that it’s been 5+ years sense it’s been serviced at all besides airing up the tires, it’s very dusty to the point that it should have been done some time ago. I think that the clutch is bad and needs a belt but not sure if the carb is making it surge or the clutch. Thanks!
Hey Kevin good to hear from you again it's been awhile! We have 5 yamaha drives at our course, that wire fails alot! The wire is constantly moving due to the motor placement. Poor design in my opinion. On average 2 fail a year. Using a longer wire helps reduce the movement somewhat, but it will fail again. Thanks for the video! I'm sure it will help alot who don't know this problem!
This is actually the first one that I've had come in with this issue. I work on a lot of Drives (routine service mostly). I usually see this on lifted carts, not stock ones.
Your favorite, the Yamaha Drive!! 😝
Hope all is good. Sure, do miss your videos
I'm hoping to be back making new videos in the coming weeks. Thank you for your concern!
I have a Yamaha g22 that i have replaced five starter generators on in the last few years. I've replaced the petal switch and voltage regulator. When running, the system charges the battery like it should. I'm lost as to what could be the issue. Any advice would be appreciated. Love the content!
Lucky for the customer it didn't end up going big bucks. Kevin, do you have a vendor or brand you prefer for an EZGO starter generator. I did a rush repair for a friend that was in a hurry and went with an Amazon starter. Well, as usual it turned out to be junk, low output 12.4v in 2 months. It won't keep the battery charged. Thanks.
I personally like to use a old school bulb style test light to test solenoids because ive seen many times a multimeter give false positive readings due to no amp load.
I use both, but my go-to is a quality multi-meter. Test lights can't show voltage drop.
Hi Kevin,
I have a 2001 club car ds that has been experiencing cut off during driving (no crank or start) for a little over a year now. A month or so ago it completely stopped and will no longer respond.
I started by replacing the microswitches which did not help, then moved to the solenoid. I replaced it and the cart sounded great, I pulled it out of the garage in reverse and drove it for a minute or two then stopped it and put it in drive. When I did this, the cart would no longer crank or start. I let it sit for a week and then tried it again. I put it in service mode and neutral and it sounded great yesterday. But then I put it in drive and it no longer responded. When I put it back into service mode the solenoid now makes a loud vibration noise when I press the gas, almost like a growling and nothing responds Today I took the starter generator out and cleaned/ checked it. The brushes looked good but inside the bell there was a lot of dust and carbon. I cleaned it up, put it back in and wired it and still am getting nothing but a solenoid growl. Voltages up the the starter generator all seem to be normal, so I am at a loss going further. Any tips or suggestions
Where has Kevin gone? Been waiting to see a new video. Been 8 months, hope everything is good with you sir
Everything is good. Its just been super busy with a lot going on. I should be back to making videos real soon.
Kevin, I recently purchased a Yamaha g29/drive, gas powered. I don’t know the year because of the custom paint job. When I got it it needed a oil change and filter cleanings, but I thought it smelled really strong of fuel, and after riding for about 40 minutes then park it, when I would go to ride it 30 minutes later it would be chokeing on to much fuel! So I cleaned the carb when I had the air box of I saw that the fan cover was filled with a rodents home, probably why it would get so hot, I greased the cluch, I know it needs one, and a belt. And a battery. But my question is : why is my check engine light on?? It has the proper oil level! And it’s only on when the petal is being pushed down. Why is that so? Nervous to ride it with it on. I googled the symptoms but couldn’t find anything so I figured I would ask you! Please help.
I would almost guarantee that the troubleshooting fault tree does not include a broken terminal. The heat shrink should help with water intrusion and corrosion.
Hi Kev. I’m Robert from Northern Ireland. I love your videos. Can you tell me how to adjust a Yamaha carburettor float level ! my float is completely plastic no metal tag that you can push up or down. My float is low and I think it should be level when held upside down !
Unfortunately, there isn't any way to adjust them.
You have to start somewhere and sometimes the angle makes things appear what they are not at a glance 🤷♂️
Sometimes the camera can see what I can't.
Hey Kevin, what’s up Dude ….? Really missing you videos ! What Happened. Best wishes.
Hey Eric! All is well. I have a few videos in the works and a couple already uploaded and ready to go live next week. Thanks!!
I wonder if kevin is making any more youtube videos❤❤❤❤
Eventually. I'm still alive lol.
@@Kevinsgolfcarts I hope all is well with you. I miss your videos. And will remain on standby for new ones
All is well. There just has been a lot going on that has taken more time than expected. I hope to get back to making videos soon.
Kevin, completely off subject. I completely lost headlights last night on my Yamaha G19 gas. I wanted check the headlight fuse but have no idea where the panel is. Ive looked all over!
Typically, the lighting circuit is just a seperate system entirely. The fuse should be, depending on the brand of light kit, by the battery. Its possible the head light switch is bad too.
@@Kevinsgolfcarts thanks, Kevin. I'll check them both! Much appreciated.
😪 'promosm'