Replacing BMW X5 Angel Eye Bulbs - What I Learned...
Вставка
- Опубліковано 27 тра 2024
- UPDATE: The other side-light bulb failed so went I for the wheel off method, still not the easiest task but MY ADVICE WOULD BE TO GET THE HEADLIGHT CLUSTER FULLY OUT FIRST: • BMW X5 Angel Eyes 😐
00:00 Intro
00:12 Parking Light Error
00:39 Halogen or Xenons?
01:00 Removing Trim
01:52 The Headlight
02:15 Bulb Cover
02:36 Bulb Holder
02:54 Bulb Holder Teardown
03:20 Which Bulbs?
03:40 Glue it Back Together
04:08 Results
If you have an E70 BMW X5 with halogen headlights, you may get a 'parking light failed' error. This is a tricky task on the halogen headlight vehicles as access is almost impossible from the top of the engine.
I'll show you how to get access and show you what I learned along the way.
PLEASE NOTE: This is for the E70 X5 with halogen headlights, not Xenons (check your vehicle first)
H10W Bulbs - ebay.us/nwII5f
Wheel Arch Trim Clips - ebay.us/hqiaYI
By clicking on one of these links, the channel GEE’s Drive may receive a commission if you make a purchase. This will directly support the channel development, Thank you. - Авто та транспорт
Great video, very helpful indeed. Does the single bulb which you replaced work for both angle eyes on the same side.or is there also a second bulb on the same side?
The single bulb works for both the angel eye rings in each headlight 👍 Glad it was useful, I couldn't find many guides for the halogens.
@@GeesDrive thanks, much appreciated.
Looked like tricky business for a small pesky bulb. Well done that man 👍
Many cuts and scratches, I'll take the wheel off and headlight out next time 🤦♂️
Just done mine but pulled the headlight out. To do this you need to loosen the front panel as the headlight wont come out the gap. To do this you need remove a fornt brace. All to change a 10w bulb. Rediculous.
I've seen another video where they pull it out the wheel well but it still involved loads of screws getting the various trims and liners out the way. Still ridiculous. You can see why BMW rectified this in later models.
@@GeesDrive Yeah. I pulled the whole light assemble out of the wheel well. Dont think you can get it unless u split the front quarter panel. And to do this you need to remove a front brace. I think the BMW engineers were laughing thinking how much trouble this H10 bulb will be to replace.
This is the bulb. Narva 12V 10W H10W Miniature Halogen Globe (Box Of 1) - 17830
Code: 90136207
Good to know, I'll pin your comment as I'm sure it'll be useful to someone 👍
Is it possible to put a more powerful LED there so that the rings work as DRL? In the xenon version there is an H8 bulb and there is no problem. In the case of halogen lamps, there is another solution, unfortunately :(
I'm sure you can get H10W LED bulbs but cannot confirm if they will work fully. My feeling is BMW know they messed up the halogens in the X5 and rectified it on the next run.
Mines is a 2017, I’ve been trying to figure this out, the little info i got says it’s a led module
I'm not sure about a 2017 but it's unlikely you will have to suffer this pain. I think it's only for halogens 07-08 in the UK and AUS.
How the fk did you get the t10 out fkkkk
why do i need to disassemble the entire car to replace a single bulb!!! arghh
What year ?
Mines a UK 2008 pre-lci, not sure if this applies to US, AU or ROW markets.
Spent half a bloody day trying to get that damn bulb out. Can’t see those two screws holding it in and don’t know what fitting they are so total blind guess work. Do you remember what fitting type and size they are?
I feel your pain, so much easier with the headlight out if you can which is what I did for the other side when that bulb went. I can't remember the exact size but I would guess either a 3mm or 4mm hex screw - 02:52
By the looks of it I’d have to dismantle half the front of the bloody car to remove the headlights. Just for a tiny blown bulb. What a piece of shit engineering.
@@pimansuki Totally right, shocking design. Wheel off, arch liner off plus a few modules and plastics plus it's a sealed unit. Crazy! I think they rectified it with the facelift and not many had the halogens but still, terrible design. Good luck 🙏
@@GeesDrive Yep - Its a nightmare -- Really the only way to do this is to remove the headlight - I know I have tried it different ways -- Its a pita for what should be simple - But its not that hard to get the headlight out when you know where the bolts are (You will need to also remove the plastic bracket thats under the headlight (some bolts are inside the engine bay) - Once you have that bracket out its pretty easy to pull the headlight down. Its a stupid design
@@ThePinktomato I had to do the other side recently and even getting the headlight out was a nightmare. You can see why they rectified this eventually. Luckily the halogen setups are fairly rare on the E70 but still, no consolation for those with them.
My garage want "£200" + VAT parts and labour. It's an awful car, always has error codes and awkward to work on. This video is brilliant thanks so I will have a go myself and let you know how long it took....THANKS
Good luck with it, I found it a pain in the butt. Headlight out is the easiest option IMO. 👍
Why no led upgrade ? So much nicer and modern looking
Personal preference really, quite like the period oem yellow look. LEDs would also look great on the E70👍
Led is risky business. They could start to flicker anytime or other stupid shit and they don’t look as nice.
Why do car manufacturers do that? Having us take off car wheels and go through so much work just to change a bulb.
Probably to get you into the dealership. Really annoying.