Terminator X walkthrough for initial startup on a common LS turbo vehicle.

[@Headhunterspeedshop]

Used this tune on my twin turbo truck, it started immediately… thanks

[@Dante-Abraham]

I wish there were more videos like this. Once the turbo set up on my Nova is all installed, i was gonna need a basic tune like this to drive the car to my tuner, Thanks!

[@Camaro-1969]

Video saved for when I get my terminator x

[@mudholemutilators9065]

Thank you for this video too btw

[@5riverz365]

Straight to the point. Earned a sub thanks!!

[@BoostedStreetJunk]

Thank you!

[@baker6366]

Me too

[@joeyevans6118]

Since my cam duration is under 235, on my lq4, would these parameters work safely as well on my application? I ran on a 60psi system NA for about 3k miles, and am going boost now. If this is a "safe to cruise" starting point before going to the dyno. That would be appreciated! Thanks

[@BoostedStreetJunk]

Yea, you shouldn’t have any issues at all with that

[@DamianCassidy-u2v]

Haven’t even opened ours yet. But I feel a lot better about it now. Thank.

[@BoostedStreetJunk]

No problem 👍🏻

[@jimhilt1652]

Just got mine installed…. Ready to turn the key.

[@MichealStevens-k5f]

Mine also has the deka 80s but not showing that option on the terminator x

[@BoostedStreetJunk]

You have to update the firmware from Holley website. Early Terminator X didn’t have all the options, but the update will put them in there

[@mudholemutilators9065]

Thanks for this bro. Can I get a link to the kit that works with that style intake? The ones I'm seeing are the one with a 4 barrel look alike throttle body

[@MichealStevens-k5f]

My 5.3 also has the deka 80s not showing that option on terminator x

[@timweb1510]

Good work

[@dandaley2644]

Any special connector needed for efi source 3bar map to Holley ?

[@351Cpowered]

I used an efi source "truck style" 3bar map sensor and it plugged right in on my terminator harness.

[@ricardoaragon3649]

is this on e85 or pump gas

[@BoostedStreetJunk]

E85