This lift kit comes with a 3 inch block. The At4 comes factory with a 2 inch block. So that would be 1 inch lift in the rear and 2 inch lift in the front which would level the truck out.
Yo I have a Denali and trying to do something like this. I have the 4” ready lift. But I have 22 that came on the truck did you have to do any cutting ?
One of the reason this set up worked is because the wheel was a 18x8 so it clears away from the upper control arm. You’re limited on sizes in a 22”. To get the height without going wide is the challenge.
Did you have to run wheel spacers in the front?
Very nice ride and and video! Too bad those Ranchos are awful
They come 2” lift from the factory I’m confused how you lifted it
So this kit lifts the truck an additional 2”.
Will these tires work with a level kit in front?
Wonder if the customer is also upgrading the brakes to stop the extra mass?
Extra mass? Calm down Newton, it may have added 50lbs with the bigger tires.
@@Jimmster66 Funniest response I've seen all year 😂
@@Jimmster66hahahaha
Did you have to use any wheel spacers to clear that ready lift uca? I just had their 1.75” level installed
No spacers were needed.
Does this set up require re-gearing? 4:30?
do you know what that raised the over height of the truck? or how mcuh it was raised from stock, would it be about 3.5-4"?
it raised it abour 3.5 to 4” with lift and tires.
Did you use the 2 inch rear block? So it was +2 inches front and +2 inches rear?
that’s correct
This lift kit comes with a 3 inch block. The At4 comes factory with a 2 inch block. So that would be 1 inch lift in the rear and 2 inch lift in the front which would level the truck out.
Yo I have a Denali and trying to do something like this. I have the 4” ready lift. But I have 22 that came on the truck did you have to do any cutting ?
One of the reason this set up worked is because the wheel was a 18x8 so it clears away from the upper control arm. You’re limited on sizes in a 22”. To get the height without going wide is the challenge.
@@DscwheelsTX 285 55 22x10 Baja MT tire
Any trimming needed after putting 35’s on it?
Since the tire was narrow 285/75R18 no trimming was required.
so basically we cant just get this truck and throw 35s on it. needs a lift kit for that im assuming?
What is the, offset for those wheels?
@@boyle1282I believe +24 or +26
I dont understand paying over 70k for a truck to put the cheapest crappiest level out there while also keeping the worst shocks.
Wait why is it crappy?