Thanks for being so specific with this topic. It’s always better to have more details than not enough. Thanks for explaining whether or not you may or may not have a petcock or whether you choose to have the whole housing or just the thermostat. The details about the gasket. It’s always nice to find a video where somebody actually explains every detail of the situation involving the topic. 99% of us get on here to learn everything we can about that specific topic and every detail counts!
I appreciate the kind words. The whole reason I started this channel was to simply help people do maintenance on their vehicles as I do it on my own. Not that I have a huge channel or following, but I also never thought it would even get to where it is right now. I'm definitely blessed by it all.
I recently had to replace my old radiator and after the install I noticed the Temp meter on dash reading a lot lower than before. It used to be almost straight up near 200. After changing the thermostat it stayed below at the second tic mark which is a reading of 185F. After investigating I find that is the correct reading. So my old radiator must have been clogged up.
Torque'sper manual on water pump housing bolts is eleven foot pounds. You can snap these bolts easily. And then if you can't get them out you have to replace the entire water pump. 11 ft pounds. Don't forget to fill the system and burp it, To get all the air out. Then top it off.
I actually did show it because the part I got has the housing and T-stat already together. It’s well worth the little extra money to buy them already together.
Didn't mention adding coolant or burping the system. Otherwise good video on replacement. NOTE: the gasket is built into the thermostat. Don't confuse it with an O ring. Prior engines used an O Ring.
How do you know if the thermostat is not working properly? My 2002 Tahoe starts to heat up only when it is stopped, when I start running the temperature drops
Old coolant, low coolant, air in the cooling system, and a malfunctioning radiator fan are all possible causes for overheating when idling but cooler temps while driving. A stuck thermostat would produce different symptoms (stuck open the engine wouldn’t reach optimal temps; stuck closed it would overheat constantly).
@@takeroadslesstraveled6505 Thanks for the advice, in my case it is probably the fan, I am going to change the fan and then I will tell you how it went, thanks friend
You don’t have to drain it but when you pull the fan shroud it ff to get the thermostat housing off whatever is in the hose and radiator above that point is going to leak out. Let it drain into a bucket or whatever and twist hose so it’s pointing straight up. Make sure housing is dry, put bolts back into housing after new thermostat is replaced, tighten bolts, put hose back on , put on shroud again and your done. U will prob loose about a 1/4 gallon if that
Man so this through me for a loop>>>> I was replacing my t stat on 04 Tahoe 5.3 and I guess the person that installed a t stat before me made a gasket for the thermostat. It made me panic and worry that I needed to make gasket for it too. It’s never leaked from there before so I guess it didn’t hurt but I knew all the videos I watched said you don’t have to use any gasket maker or anything
Could you please give me the OEM number if the thermostat housing. I have an older Chevy and the housing is different, I wanted to change it but couldn’t find a part number...
Its strange you don't have a fan or shroud to be removed for easier access to the thermostat replacement, it would have been helpful showing their removal?
Indeed it can. You can buy just the thermostat and a new gasket if you want, but the kit that has the thermostat, housing, and gasket ready to be installed is just a few dollars more.
@@takeroadslesstraveled6505 the OEM part isn’t sold separately. You have to buy the entire assembly. Maybe aftermarket brands sell them separately, but not ACDelco parts.
any reason you didn't spend the few extra dollars for an OEM thermostat? All my years on working on my car, I've learned one thing... don't trust 3rd party parts, especially alternators and starters.
They didn't have it in stock and I needed to change it out. I agree on using OEM parts, but this one got me through until I could get an OEM one and swap it over.
Aftermarket thermostat (AZ, advance, O'Reilly) is $20, OEM is $90, it's hard to make a garbage thermostat, starter and alternator are the same deal, OEM is often times 4x or 5x the price, aftermarket is just a reliable a oem in most cases
Thanks for being so specific with this topic. It’s always better to have more details than not enough. Thanks for explaining whether or not you may or may not have a petcock or whether you choose to have the whole housing or just the thermostat. The details about the gasket. It’s always nice to find a video where somebody actually explains every detail of the situation involving the topic. 99% of us get on here to learn everything we can about that specific topic and every detail counts!
I appreciate the kind words. The whole reason I started this channel was to simply help people do maintenance on their vehicles as I do it on my own. Not that I have a huge channel or following, but I also never thought it would even get to where it is right now. I'm definitely blessed by it all.
Thank you I replaced my thermostat in 20 minutes thanks to you, u rock man
Thank you i replaced my thermostast very quick by following your step to step video. Keep up the good work.!!!
Well, I’ll say it in Spanish but you will understand: Fenomenal!! Gracias
Just wanted to say your channel has been a great help with my avalanche
Very glad to hear that. If you have questions on anything related to the truck, reach out.
Thank you I'm changing mines today
Thanks, and very informative!
Thanks, brother! Excellent tutorial!
Glad it helped!
Amazing video very informative 🤙🏽
I recently had to replace my old radiator and after the install I noticed the Temp meter on dash reading a lot lower than before. It used to be almost straight up near 200. After changing the thermostat it stayed below at the second tic mark which is a reading of 185F. After investigating I find that is the correct reading. So my old radiator must have been clogged up.
Could be your thermostat I thought the same thing. But theirs 2 different types of thermostat 210F or 185F.
A clear well lit video.🤠Buddy C
Any torque settings for bolts since you are dealing with aluminum ( don't want to mush)?
My bolts keep spinning. Do you have any suggestions?
During removal or installation?
Ugh, what was the final outcome? Did you have to replace the water pump?
I would like to know if the thermostat how anything to with the shifting of the transmission
No
Torque'sper manual on water pump housing bolts is eleven foot pounds. You can snap these bolts easily. And then if you can't get them out you have to replace the entire water pump. 11 ft pounds. Don't forget to fill the system and burp it, To get all the air out. Then top it off.
great video. it didn't show how you replaced the t-stat. what do we do if the t-stat is stuck in the housing?
I actually did show it because the part I got has the housing and T-stat already together. It’s well worth the little extra money to buy them already together.
Nothing keeping the thermostat in the housing but the rubber gasket. You can't seem to get it out pull harder.
Didn't mention adding coolant or burping the system. Otherwise good video on replacement. NOTE: the gasket is built into the thermostat. Don't confuse it with an O ring. Prior engines used an O Ring.
good points
Was yours running TOO COOL or too hot? I have mine now running too cool. :)
Neither actually. I replaced the radiator, and anytime you replace a major component of the cooling system you should replace the thermostat as well.
What size you used
How do you know if the thermostat is not working properly? My 2002 Tahoe starts to heat up only when it is stopped, when I start running the temperature drops
Old coolant, low coolant, air in the cooling system, and a malfunctioning radiator fan are all possible causes for overheating when idling but cooler temps while driving.
A stuck thermostat would produce different symptoms (stuck open the engine wouldn’t reach optimal temps; stuck closed it would overheat constantly).
@@takeroadslesstraveled6505 Thanks for the advice, in my case it is probably the fan, I am going to change the fan and then I will tell you how it went, thanks friend
Nice thank you
Trying to install the gasket and thermostat into the housing is an impossible feat. Got to love engineering in the modern era 😂
Add just a dot or 2 of grease to the gasket and press gasket onto the housing, the grease will hold the gasket while you get it lined up and put on
You don’t have to drain it but when you pull the fan shroud it ff to get the thermostat housing off whatever is in the hose and radiator above that point is going to leak out. Let it drain into a bucket or whatever and twist hose so it’s pointing straight up. Make sure housing is dry, put bolts back into housing after new thermostat is replaced, tighten bolts, put hose back on , put on shroud again and your done. U will prob loose about a 1/4 gallon if that
Do you have to drain it?
Yes, the system does need to be drained.
If you don't when you pull the thermostat a lot of fluid will flow out.
I watched another video and they didn’t drain
Excellent video thank you!
Glad it helped!
Someone please tell me why you have to drain the coolant in order ro replace the thermostat?
Because it’ll pour out of the lower radiator hose when you disconnect the hose from the t-stat housing. Draining it keeps you from making a huge mess.
Man so this through me for a loop>>>> I was replacing my t stat on 04 Tahoe 5.3 and I guess the person that installed a t stat before me made a gasket for the thermostat. It made me panic and worry that I needed to make gasket for it too. It’s never leaked from there before so I guess it didn’t hurt but I knew all the videos I watched said you don’t have to use any gasket maker or anything
No gasket maker needed. The gasket is a ring style that creates the seal.
Could you please give me the OEM number if the thermostat housing. I have an older Chevy and the housing is different, I wanted to change it but couldn’t find a part number...
GM Genuine Part Number 15-11057
@@takeroadslesstraveled6505 Thank you very much.
Its strange you don't have a fan or shroud to be removed for easier access to the thermostat replacement, it would have been helpful showing their removal?
2006 models saw an update from a clutch fan with a shroud to an electric only fan setup. Mine is a 2006, hence why I didn’t show it.
I didn't pick up the 2006 model soon enough..
👏👏👏👏
сложно слить антифриз и не облить все вокруг , если нет сливного крана.
So the thermostat and be separated? I was under the understanding that it was one part and you had to buy a new housing as well
Indeed it can. You can buy just the thermostat and a new gasket if you want, but the kit that has the thermostat, housing, and gasket ready to be installed is just a few dollars more.
@@takeroadslesstraveled6505 the OEM part isn’t sold separately. You have to buy the entire assembly. Maybe aftermarket brands sell them separately, but not ACDelco parts.
why would one engineer it in such a fashion? What a horrible design.
@@DelEast740 just how the hell would he know that?
What year is that ?
mine is a 2006, but it should be the same for all Gen3 LS motors.
any reason you didn't spend the few extra dollars for an OEM thermostat? All my years on working on my car, I've learned one thing... don't trust 3rd party parts, especially alternators and starters.
They didn't have it in stock and I needed to change it out. I agree on using OEM parts, but this one got me through until I could get an OEM one and swap it over.
Aftermarket thermostat (AZ, advance, O'Reilly) is $20, OEM is $90, it's hard to make a garbage thermostat, starter and alternator are the same deal, OEM is often times 4x or 5x the price, aftermarket is just a reliable a oem in most cases
Scared me to death when camera fell
Replace the housing as well or it won't seal properly and will overheat!
What about the fan shroud did that magically come out All by its own .....also ?????
Don’t have a fan shroud cuz I don’t have a clutch fan. I have dual electric fans.
How is it you got two feet of room there to work and I get like 2 in
05+ came with the dual electric fans.
Did you magicly take the fan out ????
Nope, didn’t need to. Dual electric fans.
How to get to the 2 ..10 mm bolts ????? HUH ?????
Socket and a ratchet
The radiator magically come out all on its own
Nope, didn’t have to remove it.