Thanks for all the info. We pick up a used venom last weekend. Literally just a handful of miles, the dash doesnt light up nor the taillight, brakelight. Any suggestions? it runs fine, although we havent ran it for very long. didnt get a title only BoS/ they lost the title.
for the emissions delete do you even have to weld it? I do not have a welder... I was going to just crimp it real good and throw some JB on her... do you reckon this will work?
@@nickmark9576 Okay for sure.. Im going to start there and if it doesnt hold up I will have to find a local mobile welder. Thanks for the quick response and input dude!
BEST sounding clone on youtube no doubt ‼️
I like the Sound of the 500 dollar impact wrench banging on the rear tire was pretty gnarly😅
I did a z40 race cam and a vm26 with a 17 front sprocket it made that little 125 a monster pulled hard as hell and hits 65 mph gps no problem
What’s the link for the cam, is it a plug and play or do I need other parts and hardware to install?
Red thread locker on a chain sprocket? Dude, lol. Have fun removing that in the future. Blue is what you should have used.
the sprocket was probably covered in cosmoline to begin with so the threadlocker was probably less effective than if it were clean.
What exhaust is on your bike? Love the high mount.
Great video love to see it..
Thanks for all the info. We pick up a used venom last weekend. Literally just a handful of miles, the dash doesnt light up nor the taillight, brakelight. Any suggestions? it runs fine, although we havent ran it for very long. didnt get a title only BoS/ they lost the title.
Check the fuse under the seat? If not that check the green and red one wire connectors
Thank you for the video!!
What does deleting the control safety do?
what about the house that goes towards the tank where canister was
is there amy chance you have the links for everything??
Would you be will to ship me a third mount ready to be installed?
wtf did i just watch you speed run a grom 😂
Pretty much lol
@@nickmark9576 makes me mad to see the way you did it so fast and how long it took me 😂
@@nickmark9576 do you have a back sprocket?
@@jawwhshe cut out all the dead time in between.
for the emissions delete do you even have to weld it? I do not have a welder... I was going to just crimp it real good and throw some JB on her... do you reckon this will work?
En 50/50 it’s gets reallly hot because it’s exhaust coming out and it’s constant pressure so it would be best to weld but high temp jb weld Might do
@@nickmark9576 Okay for sure.. Im going to start there and if it doesnt hold up I will have to find a local mobile welder. Thanks for the quick response and input dude!
Would you sell the plate for the motor mount same size and the 2 holes for the bolts?
what if we dont have a welder?
You can cap it off.
@@user-uc5tj6ux8w like close the end of hose or what?
@@fernandomartinez-oh7sj Yeah or use a plate to block the exhaust port.
@@user-uc5tj6ux8w have you changed the motorbolts grade 8?
What jets are you running on the vm22 and what is your elevation
The jets that came with the carb
Yooo bro I have a stretched grom clone and I can’t get it to go up at all lol I’m not new to doing wheelies either
The purpose of a stretch is so it doesn’t wheelie hope this helps…
Squid. Longer wheel base is to prevent pop up/wheelies.
@@user-uc5tj6ux8w isn't a squid somebody who rides like an asshole putting everybody else at risk? Just asking
Probably just means a stupid rider with no gear