How To Replace Engine Mount 03-06 Mazda 6

[@pavko879]

Great job! All 3 mount in one video. Very short and clear

[@donutman3089]

Great video. Quick and to the point.

[@natemcbeth6423]

My 2006 Mazda6s 3.0L automatic has the exhaust getting in the way of pulling the bolts for the torque mount. Any recommendations?

[@stevensanchez6412]

Thanks for the info 👍

[@raymondboots6089]

Great video, good job! Than you for a great video share! Have a great one!

[@bernaljimenezgranados5560]

Par number of two sides mount?

[@maksim9863]

Does manual and automatic mazda 6 have same dog bone mount? Or different part number?

[@carfix1993]

I'm think same dog 🐕 mount

[@theprodistini2590]

Same. Recently did mine.

[@franciscouresti3378]

Does the manual and automatic have the same trans mount?

[@Pinkielover]

always support motor , when doing the mounts... Especially the top mounts.. I would've replaced the top mounts first including the tranny mount

[@csucsok82]

What is the mount brand name?
That car was benzine or disel?

[@MrMairtin]

How did you support the engine from below?
Do you have a picture of it?

[@carfix1993]

Put trolley jack

[@MrMairtin]

@@carfix1993 Ok. But where is the lifting point?

[@louisv2560]

Dato importante. Gracias por el vídeo ​@@carfix1993

[@esevato23]

What sizes and tools did you use?

[@willo6701]

It did not show that you have to put support for the engine when taking off the mounts so you keep the engine on place

[@reemarteen4813]

How much do you torque

[@pinktr_ee]

why didmt you show yourself putting support for thr engine ?

[@peaceinhands2714]

Where is u r garrage located?

[@carfix1993]

Epping

[@HewaBaxtyar1986]

Thanks

[@esevato23]

Part number for driver side mount

[@mariog.5671]

How did you avoid the motor movement? did you use any other tool and how?

[@carfix1993]

Use troll jack for underneath

[@luken6639]

Use a trolley jack with 4x4 timber, Once mount is off you can move motor by hand with trolley jack underneath carefully to line up if needed. Jack it up a little on corner of sump making sure its balanced and stable before removing top mount. Torque settings are as follows body of engine 3 bolts up to 50 ft lbs. 3 bolts on top plate 72 ft lbs.

[@heribertopena9832]

Reyena el círculo del soporte con Silicon bueno y listo

[@luken6639]

You did not use a torque wrench. A big no no.