THAT is how ALL how-to videos should be presented! There's no need to narrate as you're doing the work! Just add the narration after the fact!! SO SO great!!
Very well done and documented. Thank you. The regulator in the passenger rear of my E46 failed yesterday on me while rolling the window up. Won’t go up all the way. I’m ordering the parts for it tonight.
Mate! after 3 weeks appreciation about tackling this job I watched your video a few times, So good and I truely thank you so much for posting this, very appreciative and the job was so easy just following you along, All the Best Sir🌈🙏🏻😁
Thanks for the informative vid! I followed your guide but managed not to disconnect the airbag. It took a bit longer as I had to secure the airbag back into its place inbetween changing the regulator, and remove again to reinstall. Its worth it if you don't have the tool to reset the light though.
Thanks. Nice and clear. Did you find the aftermarket (A-Premium) piece to be precise in terms of fitting to all screw locations? Also, you plugged in that small little plastic thing in a different hole (at minute 8:00, it was unplugged at 6:45), does not matter at all?
Good catch! The aftermarket ones are ok, it depends on your budget and how long you plan on owning the car. If you can afford the BMW genuine part then I'd go with that as it will probably last longer. Aftermarket ones are hit or miss, luck of the draw really. As for the plastic clip that holds the cable, there are two holes in the door 2'' apart, shouldn't really affect operation plugging into one or the other. But good catch none the less!
Very helpful. Thank you. So our driver door window does not work. Someone tried to force it open to steal the vehicle. As a result the rubber sleeve on the outside of the window has skewed into the groove. We will use your video above to see if we can reset it. Hopefully the regulator is not broken. We have another problem with our E46 3 series model 2003 sedan. When you try and lock the vehicle it opens all the windows and subsequently does not lock the vehicle. Do you have any idea what the problem can be? Thank you
It would crunch and go very slowly once it was 3/4 of the way open. Lots of crunching and popping. So I replaced it before it got worse and let go (as they tend to - at the worst possible time!)
Doubtful you need to replace the motor. My 4 are 22 years and 278,000 miles old. Unless your regulator wires got destroyed, and allowed the motor to burn up, it's normally not an issue.
I have a question my back right passenger window falls down, and when i press for the window to go up the window goes down, is this a regulator or motor issue?
If you hear the motor moving the regulator and some banging around in the door/ clunking it’s likely the regulator. One of BMW’s all time worst design is the e46 regulator!
Mine failed and the window is stuck all the way down is there a way to get to those 8mm bolts when it’s stuck all the way down and you can’t roll it up
M3 Noah take the door panel off, cut the regulator cables with a snips and lift the glass up by hand through the frame, secure it with a suction cup tool
@@BIMMERZEITT is cutting the cables necessary? By removing the regulator motor does not that allow you to push the window up from bottom as the tension on the cables is released?...
FYI putting the window back on brackets has been a nightmare on my X5, is a tight space, plastic bracket cracked, the window can fall on your hand, it seems easy here but just remember how it all comes together before you take it apart, good luck
I bought a new window regulator with a new motor and did everything you did. When I turn on the power the window goes all the way down and doesnt go back up ? What do you think is the problem ?
I have an E46 whose window is stuck in the up position - the glass TRIES to go down, and it will sometimes go down if I press it very, very hard with my hand. Any ideas? I doubt I would be able to do a reg swap - or even see what' wrong - with the window stuck closed!
The only way to get an idea of what is going on unfortunately is to open it up. Buy a regulator, and some butyl replacement. Open it up and go from there! If you take it to a shop, they'll have to open it up and look, too.
@@BIMMERZEITT I've got some butyl roofing sealant already after having to re-stick the bottom of my other door's vapour barrier. Luckily:) I would have to keep the airbag attached and hang it out of the way; I haven't got an OBD scanner to get rid of the airbag code :(
Thanks for sharing this video with us. I like the cars but the parts are not reliable at all. The price of the car should really be far less then what it is.
BIMMER ZEIT bro awesome video please help me with the different sizes of wrenches n sockets to open all the bolts. I wanna do my self at home. I got 318i 2003 model. Please reply me back Thanks brother.
Thnkx man.. I was about to just unhook the glass and wedge something in there lol a wedge an have a electric manual window !! But 33 bones. Pretty cheap maybe I'll fix her the rite way ty. Subbed cuuuz E46ers suck!! So spread the b(u)mmer love ayyy mate
Daang that vape tape prolly 100 bucks tho !!! I'll use my duct tape maybe electric tape 2 lmao.. jk?? Idk yet.. re use wit heating it up? Prolly ❤️ 💯 I love my 46 sedan 5speed turd on 17 inch beyerns!!
WINDOW REGULATOR: amzn.to/2kcRTRj
BUTYL TAPE: amzn.to/2IwyrgV
BMW TOOLS: amzn.to/2Gzu9j8
My camera: amzn.to/2qEkaDX
Lens setup: amzn.to/2EVv4cD
THAT is how ALL how-to videos should be presented! There's no need to narrate as you're doing the work! Just add the narration after the fact!! SO SO great!!
Love the explanations and video help you provide. Makes owning a used BMW just easier than it was 10 years ago
Thank you Frank, always trying to improve on the videos that already exist out there. More details, angles, 4K resolution. Always be improving!
Very well done and documented. Thank you. The regulator in the passenger rear of my E46 failed yesterday on me while rolling the window up. Won’t go up all the way. I’m ordering the parts for it tonight.
Mate! after 3 weeks appreciation about tackling this job I watched your video a few times, So good and I truely thank you so much for posting this, very appreciative and the job was so easy just following you along, All the Best Sir🌈🙏🏻😁
Excellent vid. Super helpful. Thank You for posting.
Thanks, appreciate that!
Thanks for the informative vid! I followed your guide but managed not to disconnect the airbag. It took a bit longer as I had to secure the airbag back into its place inbetween changing the regulator, and remove again to reinstall. Its worth it if you don't have the tool to reset the light though.
Thanks. Nice and clear. Did you find the aftermarket (A-Premium) piece to be precise in terms of fitting to all screw locations? Also, you plugged in that small little plastic thing in a different hole (at minute 8:00, it was unplugged at 6:45), does not matter at all?
Good catch! The aftermarket ones are ok, it depends on your budget and how long you plan on owning the car. If you can afford the BMW genuine part then I'd go with that as it will probably last longer. Aftermarket ones are hit or miss, luck of the draw really. As for the plastic clip that holds the cable, there are two holes in the door 2'' apart, shouldn't really affect operation plugging into one or the other. But good catch none the less!
Attempting this tomorrow - wish me luck :)
Worth greasing the tracks and runners before installing?
This is only for the later models (facelift models?) as the original E46 has the mountings in different positions.
Nice video! Can you clear the airbag code with an OBD scan tool?
Great video!!
Very helpful. Thank you. So our driver door window does not work. Someone tried to force it open to steal the vehicle. As a result the rubber sleeve on the outside of the window has skewed into the groove. We will use your video above to see if we can reset it. Hopefully the regulator is not broken. We have another problem with our E46 3 series model 2003 sedan. When you try and lock the vehicle it opens all the windows and subsequently does not lock the vehicle. Do you have any idea what the problem can be? Thank you
did you put the aurbag back?
Tools used in the description would be nice. 🤗
For what reason did you replace it? It looked like it was working, although making some noise.
It would crunch and go very slowly once it was 3/4 of the way open. Lots of crunching and popping. So I replaced it before it got worse and let go (as they tend to - at the worst possible time!)
So could the motor itself not be replaced?
Doubtful you need to replace the motor. My 4 are 22 years and 278,000 miles old. Unless your regulator wires got destroyed, and allowed the motor to burn up, it's normally not an issue.
Nicely done! :)
I have a question my back right passenger window falls down, and when i press for the window to go up the window goes down, is this a regulator or motor issue?
If you hear the motor moving the regulator and some banging around in the door/ clunking it’s likely the regulator. One of BMW’s all time worst design is the e46 regulator!
@@BIMMERZEITT oh god. Guess that'll be it. Im going to check it out fully tomorrow to see whats all wrong. Thanks for this video!
Dzięki bracie pomogłeś żyj sto lat )-;;
Mine failed and the window is stuck all the way down is there a way to get to those 8mm bolts when it’s stuck all the way down and you can’t roll it up
M3 Noah take the door panel off, cut the regulator cables with a snips and lift the glass up by hand through the frame, secure it with a suction cup tool
@@BIMMERZEITT is cutting the cables necessary? By removing the regulator motor does not that allow you to push the window up from bottom as the tension on the cables is released?...
Mine is stuck at the Top and wont move.
Can i move the Glass by Hand after the Motor ist removed?
FYI putting the window back on brackets has been a nightmare on my X5, is a tight space, plastic bracket cracked, the window can fall on your hand, it seems easy here but just remember how it all comes together before you take it apart, good luck
Excellent Guide 👏👊💪👍
I bought a new window regulator with a new motor and did everything you did. When I turn on the power the window goes all the way down and doesnt go back up ? What do you think is the problem ?
did you fix it?
Thanks men
I have an E46 whose window is stuck in the up position - the glass TRIES to go down, and it will sometimes go down if I press it very, very hard with my hand.
Any ideas? I doubt I would be able to do a reg swap - or even see what' wrong - with the window stuck closed!
The only way to get an idea of what is going on unfortunately is to open it up. Buy a regulator, and some butyl replacement. Open it up and go from there! If you take it to a shop, they'll have to open it up and look, too.
@@BIMMERZEITT I've got some butyl roofing sealant already after having to re-stick the bottom of my other door's vapour barrier. Luckily:)
I would have to keep the airbag attached and hang it out of the way; I haven't got an OBD scanner to get rid of the airbag code :(
@@JMUDoc you won’t have any issue with clearing the code so long as the battery is disconnected
@@BIMMERZEITT Worth buying a reg before I start? It's only £15 (not sure what that is in Freedom Bucks these days!).
@@BIMMERZEITT I have found a very cheap reg and motor - would I be able to cut the tension wires on the old reg to drop the glass down?
Put a new window regulator on driver side. It goes up but when it goes down gets off alignment and will drop if I don’t catch it
Thanks for sharing this video with us. I like the cars but the parts are not reliable at all. The price of the car should really be far less then what it is.
David B thanks David. I am not a big e46 fan, I think the e90 is much better build quality. The 328i specifically will go for a long life
Please take a moment to visit my community page to answer a poll question here: bit.ly/2LgPDVA
BIMMER ZEIT bro awesome video please help me with the different sizes of wrenches n sockets to open all the bolts. I wanna do my self at home. I got 318i 2003 model.
Please reply me back
Thanks brother.
Wtf it is not that easy on my car
Lol I feel the same way about this.
Thnkx man.. I was about to just unhook the glass and wedge something in there lol a wedge an have a electric manual window !! But 33 bones. Pretty cheap maybe I'll fix her the rite way ty. Subbed cuuuz
E46ers suck!! So spread the b(u)mmer love ayyy mate
Daang that vape tape prolly 100 bucks tho !!! I'll use my duct tape maybe electric tape 2 lmao.. jk??
Idk yet.. re use wit heating it up? Prolly ❤️ 💯 I love my 46 sedan 5speed turd on 17 inch beyerns!!
you can use any butyl pretty much just ask at auto store. don’t reuse it, might leak water into the car!