another mistake at 1:57 +, the middle gear is shown in reverse with the tooth profile pointing up thus it will not mesh with the upper and lower gears that are shown in their correct orientation.
Ah I see, I will retry the parts with another printer. It really sucks that bambulab x1c does its own flow calculations, so I don't know how to improve the tolerance on that machine myself at the moment.@@Diplomator76
Hut ab, super konstruiert 👍👍
another mistake at 1:57 +, the middle gear is shown in reverse with the tooth profile pointing up thus it will not mesh with the upper and lower gears that are shown in their correct orientation.
There is an error at 0:21. It is not possible to slide the long rod with notch through the bearing without destroying the notch.
Yes it's true you have to put the Bearings on the axle and put it then together
How should the fitting feel like? I am having trouble getting the worm gear to right position, even when using a hammer.@@Diplomator76
@@Michael748159263 all Parts fit easy if you printer is good calibrated, if it doesn't fit, maybe your prints are not good
Ah I see, I will retry the parts with another printer. It really sucks that bambulab x1c does its own flow calculations, so I don't know how to improve the tolerance on that machine myself at the moment.@@Diplomator76
ONLY PROBLEM I'M HAVING IS, GETTING THE BARRINGS ON, TOO TIGHT@@Diplomator76
URL?
www.printables.com/model/515427-awesome-filament-spool-rewinder-upgraded