Can The Suzuki Intruder VS700 Clutch Slave Cylinder Be Repaired?
Вставка
- Опубліковано 5 вер 2024
- The state of the clutch slave cylinder on my Suzuki Intruder VS700 is worse than I thought!
__________________________________________________________________
LINKS
Get 10% off your order at Roadskin with our affiliate link - roadskin.co.uk/...
Teemill Store -
ttxela.teemill.com
Our Linktree site with the channel socials - linktr.ee/ttxe...
10% off your first order at the Brew Company with our affiliate link - brew-company.com/TTXELA
__________________________________________________________________
Business Inquires: ttxela@aol.com
I would check that the hole in the bleed screw isn't blocked with crud. If sourcing another is difficult, maybe file some flats in the bleed screw and reuse it. Also try using the centre of the vice jaws for a better grip. I've used slightly smaller sockets hammered onto mangled bolt heads etc.
On closer examination it looks like the screw has been tightened down so much it's crushed the end.
I'd call that an achievement and a step in the right direction, Alex.
Thanks, this bike is fighting me every step of the way though 🤣
Dude, great job and cool music, keep up the good work
Thanks, will do!
To be honest if it was that difficult to remove I would have left it alone and bleed the system by the banjo bolt. Loosening and tightening. Whilst pumping handle. Or pipe fitting etc. If its steel bleed nipple grind down where hex was then drill out a nut Weld nut on nipple then drill out Weld and redo pin hole. Just an idea. George anyway hope you sort it. ❤
Thanks George, I did manage to find some replacement bleed screws on eBay in the end. The old one was completely squished at the end!
At least it didn’t snap off which is what I was expecting…
🤣 I must admit I was expecting that too!
I'd guess that it is a BSP thread
Turned out to be 8 x 1.25 🙂