Це відео не доступне.
Перепрошуємо.

Troubleshooting No Spark (Honda ATC 185s)

Поділитися
Вставка
  • Опубліковано 14 тра 2022

КОМЕНТАРІ • 14

  • @MICHAEL-qv1ig
    @MICHAEL-qv1ig 3 місяці тому +1

    Thank you. Perfect lesson

  • @hattratt1458
    @hattratt1458 6 місяців тому +1

    Thanks the wire in the headlight was messing with me and it somehow got unplugged and the bike had no so I plugged it back in and the bike fired right up

  • @jerodlyford10
    @jerodlyford10 10 місяців тому

    Good vid. Thank you

  • @gabe5360
    @gabe5360 Рік тому +1

    I could not get the handle bar kill switch to read anything on run, or off. I’m leaning towards this- can the switch be cleaned/fixed without replacing it?

  • @jgonz3542
    @jgonz3542 Рік тому

    Hey Jimmy; thanks for doing this video. I got to a point where I was troubleshooting why the previous owner of my ATC put in a hotwire switch. I think this video helps me understand a little more. I only tested my Stator from the leads and didn't open the case but I think I was only seeing a resistance of 1.8ish from the black wire and grounding to the engine. This video makes it less intimidating to crack open the case and inspect. Do you put in a new gasket when you put it back together again or use "hondabond" or some such gasket sealer??

    • @blackmasta71
      @blackmasta71  Рік тому

      Hey thanks for the compliments
      Because the pull chord attaches to that side of the motor and never really seals up, I actually drilled holes in the bottom of the pull chord to drain any water.
      These stators fail because water gets in and rotts the stator while sitting.

  • @MrFireline55
    @MrFireline55 2 роки тому

    When taking my ohm reading on the stator wire (red/black) it remains at 1, no change at all. Not sure how to proceed considering the bike will spark occasionally

    • @MrFireline55
      @MrFireline55 2 роки тому

      Like I can’t get it to read at all, not even a bad coil reading

    • @blackmasta71
      @blackmasta71  2 роки тому +1

      @@MrFireline55 if you cannot get it to read at all then then the coil is broken inside and you need a new one

    • @MrFireline55
      @MrFireline55 2 роки тому +1

      @@blackmasta71 I’ve done more digging, popped flywheel off again and I’ve come to the conclusion that it has to be the spark coil, same issue you had. Thanks for the help

  • @marceloserranoros5141
    @marceloserranoros5141 Рік тому

    hey jimi mine dosnt have the coil box do u have the code by changes?

    • @blackmasta71
      @blackmasta71  Рік тому

      No off hand. I would just search a Honda parts fiche in google.
      Or just search a coil for your trike.