Come along as I add 24-volt LED lights to my 80w OMTech laser engraver! The light strip has to be 24v, at lest for my setup. I have the MF2028 - 80watt, LED Lights: www.amazon.com...
Hallo . Danke für dein Video. Ich werde bei meinem Omech 100W auch ein LED-Licht verbauen aber war mir nicht sicher wegem Anschliessen am Kontroller. Auf Anfrage beim Omtec Support wurde mir gesagt dass ich nicht am Kontroller anschliessen soll, da dieser Anschluss nicht für Dauerbelastung von über 1A ausgelegt sei. Deshalb habe ich noch ein 70W 24V Netzgerät bestellt um den Kontroller nicht zu überlasten. Schöne Festtage Ueli
Hallo kurze Frage die LEDs schon verbaut? Ich habe ein 70w Laser von Omtech und würde auch gerne noch LEDs nachrüsten. Wo wird dann das externe Netzteil angeschlossen und wie werden die LEDs eingeschalten? Beste Grüsse Philipp
Hi, thank you for the insight! Question, why don't you connect the new LED strip to the cables of the one that was pre-installed on the machine instead of creating a new cabling system?
As seen in the video at 5:47, is the pin labeled (+24V - GND) used for the laser dot on your machine? Additionally, can the LED strips be connected to this pin? I'm asking about safety concerns-would more voltage be required to power both the existing cable shown at 5:47 and the LED strips?
I believe this is correct, yes! Since I disabled the factory installed laser dot on my machine, I felt confident in using this block to make my LED lights connection.
Hallo . Danke für dein Video. Ich werde bei meinem Omech 100W auch ein LED-Licht verbauen aber war mir nicht sicher wegem Anschliessen am Kontroller. Auf Anfrage beim Omtec Support wurde mir gesagt dass ich nicht am Kontroller anschliessen soll, da dieser Anschluss nicht für Dauerbelastung von über 1A ausgelegt sei. Deshalb habe ich noch ein 70W 24V Netzgerät bestellt um den Kontroller nicht zu überlasten. Schöne Festtage Ueli
Hallo kurze Frage die LEDs schon verbaut? Ich habe ein 70w Laser von Omtech und würde auch gerne noch LEDs nachrüsten. Wo wird dann das externe Netzteil angeschlossen und wie werden die LEDs eingeschalten?
Beste Grüsse Philipp
Hi, thank you for the insight! Question, why don't you connect the new LED strip to the cables of the one that was pre-installed on the machine instead of creating a new cabling system?
I could have, I suppose. I had just watched another video of someone doing a similar project, so I figured I’d give it a try! Thanks for the question.
As seen in the video at 5:47, is the pin labeled (+24V - GND) used for the laser dot on your machine? Additionally, can the LED strips be connected to this pin? I'm asking about safety concerns-would more voltage be required to power both the existing cable shown at 5:47 and the LED strips?
I believe this is correct, yes! Since I disabled the factory installed laser dot on my machine, I felt confident in using this block to make my LED lights connection.
Hey sir what gauge are those red and black wires you used? Thanks again for the videos!!
I went with some 24g wire that I purchased on Amazon.
@@FlashHikes 10-4 sir. Thank You!!