Liberty Process LL8 Assembly With Hydraulic Drive Part 1

Поділитися
Вставка
  • Опубліковано 24 гру 2024

КОМЕНТАРІ • 9

  • @pocket5751
    @pocket5751 22 години тому

    Didn't measure from the top of the radius when it was machined in making the key small.

  • @PlaneManHehehe
    @PlaneManHehehe 7 днів тому +4

    No r e b r o a c h i n g necessary take the key down a few thousands I've done this a thousand times in the Machine Shop

    • @64timesaround
      @64timesaround 5 днів тому

      Yep

    • @Leonard-hk1nf
      @Leonard-hk1nf 3 дні тому +1

      Just did in my shed with a grinder and a flipper wheel . I am sure the tolerances isn’t the best but my pulley is on the engine !

  • @PlaneManHehehe
    @PlaneManHehehe 7 днів тому +3

    So not a very good machinist because every machine is knows that the key must be filed down to fit the key way take a few thousands off no big deal

  • @BernardBouchard-qq9kq
    @BernardBouchard-qq9kq 2 дні тому

    File to fit.

  • @christianmuller8714
    @christianmuller8714 5 днів тому

    Wie wäre es für die USA endlich mal das metrische System einzuführen. Es wird auf der ganzen Welt verwendet, außer in Malaysia und USA...
    Aber solange nicht genug Schaden angerichtet wird, solang wird sich nichts ändern.

    • @Dillybar777
      @Dillybar777 2 дні тому

      How about you worry about your own country, Fritz.

    • @Voluntarists
      @Voluntarists День тому

      Metric is terrible. 0c is mildly cold, 100c you are past dead. 0F is really cold, 100F is really hot. You're just bad at math, it's not a problem for us to convert units.