Cat 2 Installation Pat's Easy Change Quick Hitches TMT
Вставка
- Опубліковано 23 січ 2021
- Pat steps through installation of Pat's Easy Change Quick Hitch Category 2.
www.PatsQuickHitches.com
For support and questions, find email address in the About Section.
812-250-1509
Pat's Quick Hitches make hook up easy.
Pat's fits any width implement because it leaves the lift arms free.
Available sizes: Cat 1, Cat 2, Cat 1-2, Cat 2-1 - Авто та транспорт
Good instructions!
Thank you
just purchased a set and am very pleased with the quality so far, the only concern i have is the metal piece that holds up the release seems a little flimsy but otherwise they seem like a very quality item. told my friends about Pats and they are ordering (in John Deere Green obviously) within a couple days. good job and keep up the good work.
Thank you!
www.patsquickhitches.com
I am just tickled with the Pat's quick hitch I purchased
Thanks Benjy. Glad to know you like them.
Me too! Ticked fancy!!
Would Pat's quick hitch compensate for a tractor without adjustable lift arms? Thanks excellent video.
Pats Quick Hitches will work on tractors with and without extendable lift arms. Did I answer your question?
email: sherrie@patsquickhitches.com for more information.
Sherrie
I own a 2020 Kubota BX 1880 and definitely want a set but am I Cat 1 or Cat 2.
Hi Pat I have just installed your easy hitch I have a quick question regarding the ubolts I think I should cut them off now they are installed as they have about 3inches hanging down. Regards Graeme from Australia
Yes it would be fine to cut the excess off.
Glad you asked, and thanks for buying Pat's Quick Hitches.
Cutting them off would be fine.
What is the grade of the four small set-bolts, Grade 5 or Grade 8 ?
Grade 8
Pat the only problem I have with your hitch is I was bushmowing once with a sidewinder bushmower 6-8 inch diamiter bushes, and the right side hit a piece of Limb hit the release leaver and the sidewinder came off broke the left lift arm And damaded the pto shaft.
Since then I have only used standard 3 point hitch or Quick hitch where the release leavers can't be hit by brush.
You make a great product but for some applications it not the best Idea.
Thanks for sharing this. I can see how the release lever can be pushed to the side and allow the hitch to release. I think a simple solution would be to tie a piece of wire around it or possibly, drill a hole in the top of the release arm and put a bolt through it that sticks between the top of the housing. Do you have any better ideas?
@twc9000 I would put a removable cover over it, it could hook in the top and pin in the back
@@carrollsanders9376that’s a good idea. I might try to 3d print one or make it out of sheet metal.