A++ vid. Helped me out with my nitro stampede. Just bought it and its my first nitro car. I broke the thing in half the 2nd day I had it!!!! haha, damn tree came out of no where =]
Yes! I've been trying to tune my Savage 25 lately, and I may actually get it right, it's doing exactly what the Savage in the video did when the high speed needle was set too lean, sweet =]
realy usefull vids. i have an hsp warhead, did this to is after run in, clocked 65 mph on the sat nav on 25% nitro. I know the warhead is cheap, but if you maintain it well, it will give lots in return.
yes the slipper could become loose of vibrations. it could be that the look in the bolt is bad. try to change it. or it could be that you havent tighten your. so try to tight it and if it become loos change it and/or use locktight
This brings back memories. I went through all this with my Savage 25 and it was running perfectly until I fitted the reverse module and smashed the idler gear in it. It would be a very easy fix I suppose but it's been in a box for 2 years now and I haven't bothered to touch it. :(
your idle if you pop your air filter of the carb you can see the air intake hole with all the radio gear setup correctly (check your trims remember) it sould have a 1-2 mm hole with it all setup right
With all the "hop up" gear kits for trucks, do you think it's really practical to put in ratios that make the truck even faster? Given the fact that the tires do "balloon" at high speeds, making it go even faster may throw the vehicle off balance, wouldn't you say? I've seen my trucks balloon when I did a turn. It looks cute and funny. But the tire was in the air as it ballooned.
this happerns to most NEW rc models. With mine i just floored it a few times, the engine sized a few times but it this happerns just leave it alone for a day or too and it should fix it. In short: Slowly rev it upto max. Quickly rev it to max (With new models it might take a few tries coz it stalls) OR make it richer. (Unless you havent changed the settings from fractory)
no it is not a self igniting feul like diesel it uses a "glow plug" dat keeps itself hot by the contineus combustion in the combustion chamber therefore it is more like a gas engine
im considering getting one but i noticed the cost of nitrotane fuel...not the cheap, so i was wondering if rc cars the run on nitrotane also run on just ur normal everyday gas?
ALWAYS GET A NEW GLOW PLUG WHEN TUNING i learned my lesson i used a old one and its died at full throttle all the time but when i put a a new plug and it ran like new
hey my car (rc10gt) first doesnt want to start and then when it dies if it gets anywhere close to idle. it will not run at rpm's low enough that the clutch isnt engaged. what do i need to do? i know the engine is not worn out because it has good compression. i know the glow plug and igniter are fine and im pretty sure it isnt my fuel too. the tube going from the pipe to the tank is about 2". could that be the problem? if not what should i do? the local hobby shop didnt really help. thanks
it cuts out cuz of the plastic part that connects to the breaking arm (im so bad at discribing) but its broken, i removed mine all together, jsut put the servo screw thing right against the arm and it will be fine
im having a problem with my monster MT, it starts ok but once i tap the revs a little it just blurs and cuts out, i dont know wat screw to turn down to fix it, im prity new at these so i dont know much atm, any help would be gr8
of course compression ratio is lower nitro fuel is alot more combustible than diesel.... diesel gas is not even flamable, so therefore you need to understand the characteristics of compression or pressure both of which equals heat, that is why diesels run at such a high compresion ratio. nitros dont use gasoline technology because they are so small and they would sacrifice alot of excess weight due to extra parts. except for fifth scales and above.
can someone help me please because when i run my car for a while and the engine gets warm my engine starts reving at idle can someone plz help me it does not rev when it is just warm only when its a little hot.
i have 2 rev my nitro rtr 3 evo b4 it will move at all n wen it does it just sounds boggy like the exhaust has water in. it barely reaches 2nd gear becuz of that.
can anyone help me i got a ofna buggy and when i start it it starts fine and runs buy as soon as i take the glow starter off it dies plz help me never has the probleme
ur idle needle is too low, turn it clockwise to increase ur idle. when u let off the throttle, the carberator or however u spell it is closing too much an cutting off the engine.. but there could b other reasons.
This video actually helped me with one of my problems! Time to do some major re-tuning on my car. I love that this video has demonstrations!
A++ vid. Helped me out with my nitro stampede. Just bought it and its my first nitro car. I broke the thing in half the 2nd day I had it!!!! haha, damn tree came out of no where =]
these are toys for the big boys! I love how those donuts expand at WOT!
Yes! I've been trying to tune my Savage 25 lately, and I may actually get it right, it's doing exactly what the Savage in the video did when the high speed needle was set too lean, sweet =]
best tuning vid on youtube
Lean out your Low speed needle and richen your High speed needle no worries just dont go full throttle until you have it sorted
realy usefull vids. i have an hsp warhead, did this to is after run in, clocked 65 mph on the sat nav on 25% nitro. I know the warhead is cheap, but if you maintain it well, it will give lots in return.
very helpful, seeing how much smoke is too much and too little
yes the slipper could become loose of vibrations. it could be that the look in the bolt is bad. try to change it. or it could be that you havent tighten your. so try to tight it and if it become loos change it and/or use locktight
excellent video
This brings back memories. I went through all this with my Savage 25 and it was running perfectly until I fitted the reverse module and smashed the idler gear in it. It would be a very easy fix I suppose but it's been in a box for 2 years now and I haven't bothered to touch it. :(
perfect explanation! thanks!
your idle if you pop your air filter of the carb you can see the air intake hole with all the radio gear setup correctly (check your trims remember) it sould have a 1-2 mm hole with it all setup right
very helpful, thanks.
im with this guy he knows what his on about and hes right :p i work on my hilux a real truck alot :P nice vid to hatparr shhhhhhooosh
revopwns i had that problem with my t maxx i had t keep starter in for it to stay runnin g try buying a new glow plug it worked for me
when the wheels speed up, basically the g-force created forces the inswet outward
With all the "hop up" gear kits for trucks, do you think it's really practical to put in ratios that make the truck even faster? Given the fact that the tires do "balloon" at high speeds, making it go even faster may throw the vehicle off balance, wouldn't you say? I've seen my trucks balloon when I did a turn. It looks cute and funny. But the tire was in the air as it ballooned.
@sqeker09 Noooot quite. It's just centrifugal force.
its cause to the sentrifugal force wich appears when the wheels spinn fast
on second thought, dont aim for temps aim for good power and smoke.
Thankyou for telling me.
awesome
expanding tires....i like dat
nice tuning u got it to do a weely
this happerns to most NEW rc models. With mine i just floored it a few times, the engine sized a few times but it this happerns just leave it alone for a day or too and it should fix it.
In short:
Slowly rev it upto max.
Quickly rev it to max (With new models it might take a few tries coz it stalls)
OR make it richer. (Unless you havent changed the settings from fractory)
thank you
haha well put :P
no it is not a self igniting feul like diesel it uses a "glow plug" dat keeps itself hot by the contineus combustion in the combustion chamber therefore it is more like a gas engine
im considering getting one but i noticed the cost of nitrotane fuel...not the cheap, so i was wondering if rc cars the run on nitrotane also run on just ur normal everyday gas?
nieżle daje :] hes are realle fast :D nice jop :]
for the low end needle can you also do the pinch test?
the tires is like expanding
best vid ever, if only they gave some tempuratures to aim for
what gearing are u using in this vid. Your 25 is fast. I have a 52spur and 18bell. Yours is almost doing wheelies
the fist fuel you ever put in it is what you need to run
Thanks
how do u charge the glow plug ignitor? I'm new to this hobby and I am getting one for christmas.
ALWAYS GET A NEW GLOW PLUG WHEN TUNING i learned my lesson i used a old one and its died at full throttle all the time but when i put a a new plug and it ran like new
do's the same apply when changing fuel percantage from 16 to 20 percent and what is the low speed needle
did anyone notice when it was sitting on the block, the tires freakin grew when he gave it some gas?
hey my car (rc10gt) first doesnt want to start and then when it dies if it gets anywhere close to idle. it will not run at rpm's low enough that the clutch isnt engaged. what do i need to do? i know the engine is not worn out because it has good compression. i know the glow plug and igniter are fine and im pretty sure it isnt my fuel too. the tube going from the pipe to the tank is about 2". could that be the problem? if not what should i do? the local hobby shop didnt really help. thanks
your low speed needle is to lean or rich its either starveing or flooding itself
it is.... But he's insured by HPI, so it doesn't matter him ;)
hi i took it to the hobby shop they tuned it for me but when i got home i started it up but when i try to go full trottle it drive really slow.
do a Tuning vid with the savage xl
My engine makes a struggle sound when decelerating from top speed and sometimes attempts to shut off. Is that a bad sign?
im gonne buy a kyosho inferno US sports. what do you guys think about the inferno?
it cuts out cuz of the plastic part that connects to the breaking arm (im so bad at discribing) but its broken, i removed mine all together, jsut put the servo screw thing right against the arm and it will be fine
wow do this RC has an diesel version of engine?
yes please have one for an XL
im having a problem with my monster MT, it starts ok but once i tap the revs a little it just blurs and cuts out, i dont know wat screw to turn down to fix it, im prity new at these so i dont know much atm, any help would be gr8
ok ty ill try it
what kind of truck did yall use
centrifugal i think
@HawgDawg11 hey i need help my hpi mt2 just starts acselarating by it self when i start, what do i do ? thanks
whats up with the wheels they get bigger as you floor it
wtflook at that weelsthey are growing and is the Koysho DST a good car coes i want to buy it
How come when I run my T-Maxx with the wheels of the ground it stalls, but in this video it doesn't. In fact the tires are able to baloon!
of course compression ratio is lower nitro fuel is alot more combustible than diesel.... diesel gas is not even flamable, so therefore you need to understand the characteristics of compression or pressure both of which equals heat, that is why diesels run at such a high compresion ratio. nitros dont use gasoline technology because they are so small and they would sacrifice alot of excess weight due to extra parts. except for fifth scales and above.
i have a single needle carb how do I tune the lsn?
my moster truck keeps cutting out for no reason its all set properly but it cuts out and now it wont even start i dunno what to do please help
Uhh.... did you just forget to look at the title, and skip to the high speed to lean part and leave a comment?
He didn't made the video himself, it is one of the savage DVD video's you get if you buy an HPI product. How do i know? i have the DVD :D
Just bought a 2nd hand truck....anyone know why it runs fast when i start it up?Im new to this so i really dont know a great deal.Thanks.
FActory setting of a savage is that ALL the needles are flushed with the needle body's..
Were did you get it from
NO! Nitromethane engines CAN NOT run on regular gas. Nitromethane engines are 2 stroke engines and do not have a spark plug.
i have tryed all of this but my engine still shuts down when i leave it to idle. i even riched high speed and low speed but it still shuts down.
are giovanni rc's any good?
@bradyvice33 make a video. and try richen high speed needle
is it me or did the tire get bigger
Where can i get one of these ?
Hello, if you truck rolls forward at idle your clutch is weak. Cheers.
HI i have cen mg16 moster is it ok to run it on 20%
can someone help me please because when i run my car for a while and the engine gets warm my engine starts reving at idle can someone plz help me it does not rev when it is just warm only when its a little hot.
does any one have any advice my car start put it full trottle it will not move and the engine make a noise like it is dieing
it doesnt matter, they make the car.
it won't whan its on the ground ya?
low speed flat & i dont know about factory setting, but on the high speed....all the way in & out 3 turns.
yep
nitro rc saved my life of drugs it got my mind off them
so wat ur saying is i can use the sht i use for my weedwacker...
i have 2 rev my nitro rtr 3 evo b4 it will move at all n wen it does it just sounds boggy like the exhaust has water in. it barely reaches 2nd gear becuz of that.
can anyone help me i got a ofna buggy and when i start it it starts fine and runs buy as soon as i take the glow starter off it dies plz help me never has the probleme
ur idle needle is too low, turn it clockwise to increase ur idle. when u let off the throttle, the carberator or however u spell it is closing too much an cutting off the engine.. but there could b other reasons.
too rich, dont worry about runing things, you will soon be able to tell
change the glow plug os # 8 o a3
tem videos em portugues?
What are the factory settings for a savege hpi can anybody help plesasssssse!
High Speed
even bigger cost i guess
if it takes off rite away it my be your clutch
can someone plz tell me why my breaks dont work?
can any one help me my nitro monster truck starts but if i do not drive it i cuts out can some one help me plz
they're out of adjustment
so not good for it ....revving it when off the ground, can snap drive shafts
i thought it was centrifical force
explanation fail.
It's called centrifugal force.
4 how much
nitro