Steve Cutajar I take the cable off at the hand lever by removing the hand lever. That way I can just stick the clutch cable in at the engine and there's plenty of slack to do it. I might carefully use a small hex key to get the wire in. Then I put the lever end of the wire on the removed lever and age it back into place from there. Done
Is it necessarry that the big hemisphere (not the small sphere in the middle) on the pressure plate is intact? Mine has a little dent!
hey mate. nice vid... question... how did you connect the clutch cable after putting it back before hooking the clutch cable?
Steve Cutajar I take the cable off at the hand lever by removing the hand lever. That way I can just stick the clutch cable in at the engine and there's plenty of slack to do it. I might carefully use a small hex key to get the wire in. Then I put the lever end of the wire on the removed lever and age it back into place from there. Done
How do you know how much to tighten the spring bolts?
hand tight (7nm)
thanks!