RD350LC Engine assembly part 2
Вставка
- Опубліковано 18 кві 2020
- Second part of the Yamaha RD350LC engine assembly.
Music:
Sunspots by Jeremy Blake
Stranger Danger by Francis Preve
We could reach by Freedom Trail Studio
Slow times over here by Midnight North - Авто та транспорт
U are my hero I striped my tamaha RD 350lc engin 11 years ago I was 16 now im rebuilding it thank you sir you are the best. slow step by step I highly appreciate it 12 out of 10 Thank you
Good work and im ready to share your neat work and full support for your channel from my side
Very clean WORK very good video thank.
Great work 👌
Thanks!
Will be wonderful if you share the torque values for the case bolts, head bolts, clutch nut etc. Thanks in advance, great video and lovely way of working!
Thanks for your comment. That would be nice indeed. I will think about it when editing a next project. Sorry for the late reply.
The pillows that the 6 bolts go into brake off easily don't over tighten
That's right.
Very cool. Thanks for the share.
Thank you!
great work
Thank you!
The clutch basket seemed dry, didn't you oil it before putting it on the axis
I have ruined the screws with the cross head you put at the beginning of the video, can I replace them with hexagonal head bolts or have the screws been put in for a specific reason?
You have a table / link where to see the tightening of the engine bolts, thanks.
the iron plate. sharp edge should face to inside or outside?
I assume you mean the plate that holds the bearing of the main shaft in place. That is rounded edge outwards, sharp edge inwards. At least that is how I mount these.
Perfekt job💪