How to Replace Your Accelerator Pedal Position Sensor - Accelerator Pedal Replacement

Did this video Help?
Show your appreciation and Buy Me a Coffee - www.buymeacoffee.com/offthesh...
OSR Garage shows How to replace the Accelerator Pedal Position Sensor on your vehicle. The Accelerator Pedal is attached to most sensors but it will depend on your vehicle. We were replacing because we had a dead spot in which there was no power when pressing down the accelerator.
** For Business or Collaboration interests - Contact me at [e-mail] **

[@8490JJ]

How long did this take you?

[@SavageAccuracy100]

Thanks so much my dude! I'm a women who likes to work on my car if I can and your video really helped! Very detailed. Thanks so much again 💕

[@Quantum369Mechanic]

i wish I had a bad pedal! -2013 Camry 4cyl. mine is so sensitive it's impossible to drive.

[@user-hn2qo7dl6w]

Is it possible for it not to throw codes? I have a dead spot in my pedal.. when I first press it'll take a while to get speed then once I'm going it's fine. No check engine light

[@alternateimpact81]

Im surprised that your vw didn't go into limp mode with the old pedal

[@motologist1917]

can we fix the old padel , my car padel also takes little time to accelerate

[@mark.r8900]

Great video. My 2007 audi a4 intermittently goes into limp mode. It intermittently only happens when I slowly accelerate from a stop. Like from a red light. When light turns green and I pressed pedal slightly that's when it goes into limp mode. Once it starts going it's ok. The throttle body under the hood looks ok. Can this pedal be my problem? Any help would be greatly appreciated. Thank you

[@maddog9793]

You didn't have to wipe off fault codes?

[@xNiff]

My live data saya that the accelerator position is at 90% while at idle and not accelerating.. any sugestion?

[@brentwitte1645]

2012 jeep compass 2.4l what the stap for it?

[@antionnehenry7493]

Great video helpful with diognoses and repair thanks

[@franksh2023]

Thank you for sharing!

[@TyroneMaye]

how do you test the connector to the accelerator pedal position sensor using the multimeter ? checking for 5volt reference and the ground from same ? Don't you have to go into the system to clear the EPC code which was thrown ? Or is this process for the Audi Q7 3.6L V6 engine as well ?

[@mariannehyderkhan2370]

Thank you. I have a fixed module. And, I have a 2003 Nissan Pathfinder. Parts will not be in for a week. Is it safe to drive until then? Been throwing this code this code since I got a new battery installed a month ago. This morning was the 1st symptom shown... hesitant to accelerate. I panicked. Parts will not be available for over a week. My question. Is it okay to drive until then? Thank you.

[@delhiabbas]

Thanks for sharing

[@FumiyaSugawara]

Have this issue on my Mazda 3, but am replacing the pedal and the throttle body motor which goes in conjunction with the accelerator.