How to replace accelerator pedal sensor | Gas pedal | Accelerator pedal | Complete guide

Поділитися
Вставка
  • Опубліковано 13 чер 2021
  • ua-cam.com/users/rajsilverauto...
    SYMPTOMS OF A FAULTY ACCELERATOR PEDAL SENSOR: SYMPTOMS:
    1.If the accelerator pedal sensor fails, the following fault symptoms may occur:
    2.Increased engine idling speed
    3.Vehicle does not respond if the accelerator pedal is pressed
    4.Vehicle switches to "limp-home mode"
    5.Engine warning light in the cockpit illuminates
    ACCELERATOR PEDAL SENSOR FAULTY: CAUSE OF FAILURE:
    1.Damaged cables or connections on the accelerator pedal sensor
    2.Missing voltage and ground supply
    3.Faulty electronic evaluation unit in the sensor
    The following test steps should be considered during troubleshooting:
    1.Read out fault code
    2.Visual inspection of the accelerator pedal sensor to check for mechanical damage
    3.Visual inspection of the relevant electrical connections and cables to ensure they are properly fitted and for any damage
    4.Check of the sensor using an oscilloscope and multimeter
    Accelerator pedalPedal malfunctionGas pedalPeugeot accelerator pedal sensorAccelerator pedal sensorthrottle pedalthrottle pedal replacementgas pedal replacementaccelerator pedal replacementgas pedal removalford accelerator pedal replacementthrottle pedal removalford throttle pedalfor throttle pedal replacementford gas pedal replacementford focus throttle pedalpeugeotPeugeot 308 pedalpeugeot 208
  • Авто та транспорт

КОМЕНТАРІ • 14

  • @testrasta6695
    @testrasta6695 Місяць тому

    How to get the gas pedal sensor for the nissan lafesta mr20

  • @az094617
    @az094617 2 роки тому +1

    Good video

  • @laszlocsoknyai1684
    @laszlocsoknyai1684 Рік тому +2

    Thank you for the video. That's fine so far. Easy to replace. After that, can I drive the car immediately or does it need to be calibrated? Specifically for the GM/Opel (2018) model.

  • @melissaclark4676
    @melissaclark4676 Рік тому

    I know this video is old but will it auto calibrate on a 2005 Ford freestyle or do I need to have someone else calibrate it for me?

  • @mihai-ioanbraga6594
    @mihai-ioanbraga6594 Рік тому

    I have this problem P2138 on an Opel Mokka 2015 1.4 140 ps (I changed the pedal, the cable that goes to the computer, and it still appears the same to me, can you tell me what could be the cause?? so far I have invested 1500 euros in parts , I also went to Opel and I don't know what the problem is 😞

  • @BuysaveSA
    @BuysaveSA Рік тому +1

    Can this also be replaced with just the sensor part and not the whole pedal on a Hyundai i20

    • @rajsilverautolearn
      @rajsilverautolearn  Рік тому

      Yes can ..if sensor came separately then just change the sensor only

  • @vickyarenstig6306
    @vickyarenstig6306 Рік тому

    how expensive are they?

  • @sclogse1
    @sclogse1 2 роки тому

    I was hoping other people would have added comments. A friend with a Volvo has no acceleration, and can't figure out if It's because of the linkage, the sensor, or the shifter. And he has a Volvo repair shop.

    • @UserName-cb6jz
      @UserName-cb6jz 2 роки тому

      My VW lost the gas pedal control after running through a water puddle.
      I have been told it's never the pedal, but the connectors or wiring from the pedal to the computer. Right now it's being serviced.
      If it's not that, his Volvo's MAF sensor could be dirty or bad as well.

  • @kevinharper435
    @kevinharper435 Рік тому +2

    Why don’t you tell people what you’re working on.

  • @alexandruduta8102
    @alexandruduta8102 9 місяців тому +1