How to Replace Rear Shock Absorber 2005-2010 Chevrolet Cobalt
Вставка
- Опубліковано 23 чер 2022
- Buy Now!
New Shock Absorber from 1AAuto.com 1aau.to/ib/1ASHA00187
This video shows you how to install shock absorbers on your 2005-2010 Chevrolet Cobalt. Shock absorbers help your vehicle stay stable and safe. Signs of worn out shocks are knocking or bumping noises, loose handling, or a bouncy or bumpy ride. The typical service life of a shock absorber is 50,000 miles, depending on conditions. TRQ shocks and struts are engineered to fit your vehicle perfectly.
This process should be similar on the following vehicles:
2005 Chevrolet Cobalt
2006 Chevrolet Cobalt
2007 Chevrolet Cobalt
2008 Chevrolet Cobalt
2009 Chevrolet Cobalt
2010 Chevrolet Cobalt
Tools you will need:
• 18mm Socket 1aau.to/ogt/1AXAA00043
• 19mm Socket 1aau.to/ogt/1AXAA00043
• 21mm Socket 1aau.to/ogt/1AXAA00043
• 1/2 Inch Air Impact Gun 1aau.to/oaZ/1AXAA00252
• Torque Wrench 1aau.to/oiS/1AXAA00044
• Liquid Thread Locker
• Wire Brush 1aau.to/obd/1AXAA00079
Subscribe: / @trq
Check out our playlist:
Chevy Cobalt 2005-2010 1st Generation: • Chevy Cobalt 2005-2010...
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video. - Авто та транспорт
√ Watch the Video
√ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts
√ Do it Yourself
√ Save Money
Just changed out the rear shocks and coil springs in an HHR which is an identical process and had major trouble extracting the bottom bolt from one of the shocks. The bolt was rust-welded inside the shock's retaining cylinder (I didn't know that was a thing) and it took a combination of brawn, heat, PBB, patience, and cuss words to extract it. The angle-grinder lent a major assist, too. A good two hours of nonstop effort went into that job. Amazingly, the bolt itself is fine.
Great video! Very clear and direct instructions from beginning to end, and the visuals helped very much! I'm not much of a car guy but this video gave me confidence in fixing my car. Thanks and keep up the great work!
Did you guys pull this car out of a lake? The rust is insane! Great videos though as usual
Lol
Thank you so much
You're a life saver 🙏a lot of what you did is very in depth and not needed unless you want the car to outlive your grandchildren but I like that everything was shown with care and specifics
Is it gaz or oil shock?
Like your style, but alignment after rear shock replacement?!? C’mon man.
Car is rusted bad, won’t be long.