Just grab the carbs at the top and pull back. It puts even pressure on all of them and won't loosen the connection from bending them by only pulling one.
if you replace your hardened coller rubbers? which arent expensive, then apply a smear of sylicon grease to both the new rubber and alloy flange! the carbs will push on snug and not require any form of hammering!
Thank you so much for uploading this very detailed video, will get couple thousand views ,only complain ,plz consider upgrading Camara quality besides that it's great video.
Thanks for sharing. Would not have been able to get carbs off without pry trick!
same here! Just did it, seemed impossible to get the carbs off without the pry trick!
Just grab the carbs at the top and pull back. It puts even pressure on all of them and won't loosen the connection from bending them by only pulling one.
Thank u very much, this was extremely helpful
if you replace your hardened coller rubbers? which arent expensive, then apply a smear of sylicon grease to both the new rubber and alloy flange! the carbs will push on snug and not require any form of hammering!
Que pasa sino conectas esas 3 mangueras de arriba?
What holes did u plug up since you dont have the vaccum system on it?
Great video, thank you.
Is the jumbo screwdriver a Philips or regular flat head?
THANK YOU
Thank you so much for uploading this very detailed video, will get couple thousand views ,only complain ,plz consider upgrading Camara quality besides that it's great video.
Видел как снят