After The Pour- How to process an ingot into sheet. Sterling Silver

Поділитися
Вставка
  • Опубліковано 28 лис 2024

КОМЕНТАРІ • 13

  • @bernettetodd2038
    @bernettetodd2038 2 роки тому +1

    Wow! Loved every minute of this. And thank you for the advice about low back issues and rolling mills.

  • @tywhitmire860
    @tywhitmire860 2 роки тому +1

    A gorgeous ingot! Thank you!

  • @jamesmuthukui9355
    @jamesmuthukui9355 Рік тому +1

    Nice job keep it up from Kenya 🇰🇪 Africa 🇰🇪

  • @RaduButarascu
    @RaduButarascu 2 роки тому +1

    Thank you for sharing this - this is hard work!

  • @RedmanOutdoors366
    @RedmanOutdoors366 2 роки тому +1

    This is a lot harder than it looks nice piece of sheet 🤠👍💯🇺🇲

  • @antoniamacias9943
    @antoniamacias9943 Рік тому +1

    you did so good

  • @stonearches2883
    @stonearches2883 Рік тому

    Nice job. I’ve always had difficulty rolling sheets. I get cracks and bubbles. I did buy a mill with the gear reduction and it’s still a lot of work to roll sheets. Thank you.

    • @TracyGrossDesign
      @TracyGrossDesign  8 місяців тому

      The trick is to hammer the ingot before you roll to prevent the bubbles. Thank you for watching!

  • @Cindjo717
    @Cindjo717 2 роки тому +2

    Thanks so much! What’s the name of the sanding at attachment that you used.

    • @TracyGrossDesign
      @TracyGrossDesign  2 роки тому +2

      They are 1 inch sanding discs I found on Amazon 😊

    • @lynsixty
      @lynsixty 10 місяців тому

      Can you share the link? Thanks.

  • @NobleArtDimensions
    @NobleArtDimensions 2 роки тому +1

    Thank you for this 😁

  • @hollyprentice7065
    @hollyprentice7065 26 днів тому

    Can you show how to do the plate pour? Mine just bunches up on top and doesn’t flow down ty!