Any recommended procedure or puller tool to remove a pinion secured with loctite as you suggested? I hate to use a torch on a nearly new motor. I am installing 3mm thick plates between each motor face and the bearing carrier. My motor shafts protrude slightly beyond the end of each pinion, not worried. These plates will provide attachment points for a stabilizer, lights, camera, etc. Not easy to find bracketry that fits yet another novel hanger cross-section :) (I have your 104mm gearboxes on your finality trucks, not hypertrucks, but motor carrier plates are the same.)
Hello I buy the trucks and geardrive but I am confused how to mount ut to my board. The base plate of the trucks have so many holes. Can you please make a how to mount to board video?
Impressive looking, would Lacroix offer this as an option ? worth inquiring ?
I would be assuming that So much red locktite makes maintenance nearly impossible. Looks amazing but no torches for me.
Any recommended procedure or puller tool to remove a pinion secured with loctite as you suggested? I hate to use a torch on a nearly new motor. I am installing 3mm thick plates between each motor face and the bearing carrier. My motor shafts protrude slightly beyond the end of each pinion, not worried. These plates will provide attachment points for a stabilizer, lights, camera, etc. Not easy to find bracketry that fits yet another novel hanger cross-section :) (I have your 104mm gearboxes on your finality trucks, not hypertrucks, but motor carrier plates are the same.)
Will it be possible to have a 3" hub? This creation is amazing
Hello I buy the trucks and geardrive but I am confused how to mount ut to my board. The base plate of the trucks have so many holes. Can you please make a how to mount to board video?