Hey brother i’m sure a new to this so please forgive me put those big black boxes on the back of your board with the wires from the motors going into them. What are those ?please and thank you sir
Hello I buy the trucks and geardrive but I am confused how to mount ut to my board. The base plate of the trucks have so many holes. Can you please make a how to mount to board video?
Any recommended procedure or puller tool to remove a pinion secured with loctite as you suggested? I hate to use a torch on a nearly new motor. I am installing 3mm thick plates between each motor face and the bearing carrier. My motor shafts protrude slightly beyond the end of each pinion, not worried. These plates will provide attachment points for a stabilizer, lights, camera, etc. Not easy to find bracketry that fits yet another novel hanger cross-section :) (I have your 104mm gearboxes on your finality trucks, not hypertrucks, but motor carrier plates are the same.)
Hey brother i’m sure a new to this so please forgive me put those big black boxes on the back of your board with the wires from the motors going into them. What are those ?please and thank you sir
those are esc(electronic speed controller) probably Vesc type.
Wow that easy
Hello I buy the trucks and geardrive but I am confused how to mount ut to my board. The base plate of the trucks have so many holes. Can you please make a how to mount to board video?
Any recommended procedure or puller tool to remove a pinion secured with loctite as you suggested? I hate to use a torch on a nearly new motor. I am installing 3mm thick plates between each motor face and the bearing carrier. My motor shafts protrude slightly beyond the end of each pinion, not worried. These plates will provide attachment points for a stabilizer, lights, camera, etc. Not easy to find bracketry that fits yet another novel hanger cross-section :) (I have your 104mm gearboxes on your finality trucks, not hypertrucks, but motor carrier plates are the same.)
I would be assuming that So much red locktite makes maintenance nearly impossible. Looks amazing but no torches for me.
Impressive looking, would Lacroix offer this as an option ? worth inquiring ?
That's cool what esc are you using to do that how?
Will it be possible to have a 3" hub? This creation is amazing
The Helical Gear sounds very good, low noise and seems to cool smoothly. Will the Gear drive accept 6374 Motors ?
Suitable for all 63xx motors .