Nissan YD25 Turbo problems and how to fix free live Draw!!
Вставка
- Опубліковано 5 жов 2024
- In this video we draw the winner of the turbo and further advice about why turbos can fail. Once again we want to thank all for your support over the last few months without you guys the channel would of not been possible so thank you all bring on the rest of 2021 working together. Please get in touch if you need our help and support 01274 640028 email westyorkshireengines@gmail.com
www.maxpeedingrods.com For really cheap parts why order from Euro Car Parts when you can cut out the middle man!!
/ 179341679478752 Join Nissan Navara Club UK Facebook
![[UA] NAVI проти G2 Esports | Blast Premier Fall Final](http://i.ytimg.com/vi/QWlIm4FGESQ/mqdefault.jpg)
Hello Des, Hello from Australia 🇦🇺. Thanks for your help, love your videos.
Learnt so much in 5mins from you vid! Thank you from NZ
Hi, greetings from Chile.
I have a '09 Pathfinder with egr and no dpf (I believe that dpf comes in the facelift); first it poke a hole on the lowest point of the piston crown and then through the side of the piston, 4 new pistons and rings later and after a couple of days it broke the shaft of the turbo (it made a horrible noise and black exhaust). Later we found that the oil line for the turbo was leaking and assume that the turbo started to fail when the hole was created.
After installing a brand new turbo from a Navara, code EB70A, (the turbo code for the pathfinder is EB300), we found that the low oil pressure light turned on when stationary (ie. traffic lights), and then turbo started to make some noise; further inspection we found out that it was leaking from the valve cover, the turbo feed line was dry and the turbo noise came from oil starvation (the shaft was a bit loose and some sratchs on the housing, as well as the engine connecting rod bearings that had some excesive wear (apparently because of oil starvation)
I have some suspects
Oil pump (I saw on internet that the gears inside of it start to wear), Inyectors (I would like to ultrasound cleaning them, and testing on a bench; is that reccomendable?)
Engine temperature (because it has an electrical fan, the operating engine temperature is lower than the middle of the temp gauge), but I believe this problem is for yd25's with dpf, Am I right?
What are your opinions on the suspects, what I also found in the several oil changes, it was that in all of them it came thin oil.
Thank you very much. I like the channel
You can reprogramme deletes back into an ECU (at least with Nissans) I had a J10 come in with a sluggish engine but no codes stored. Had a look round the engine bay and the EGR connector was taped up and disconnected. Seeing as this didn't bring any codes I figured it could have had a remap. I checked for any updates and found an ECM update available, did the update and it brought up EGR open circuit and P2002 for a blocked DPF. Turns out the car had been remapped and had the EGR and DPF deleted from the ECM which meant the car didn't regen and blocked the DPF causing lack of power. We've had a couple of instances where J10's have come in for the engine update recall but have previously been remapped causing a whole load of grief when we then tell the customer that the update has allowed the ECU to recognise faults with their car and is keeping the EML on. I can see why they get frustrated, to them there was nothing wrong before and now they need hundreds or possibly thousands of pounds worth of work done just because they came in for a free update. Gotta love recalls on old cars.🙄😒
ATOM314159 nice one buddy we need information of the people who can do this we have lots of customers who need this doing everyone we have sent the motor to go back to standard it was not possible so we need phone numbers and places to send people we will allow this thanks buddy
@@westyorkshireengineservice9160 Any Nissan dealership with Consult 3 software on their diag computer should be able to do it. There may be cases where the remap bricks the ECM, but normally the Nissan update writes over the previous data keeping the injector codes, so it should erase the remap and put in the Nissan software. You may even be able to wipe the ECM completely and then try programming it like a new blank ECM, if a straight forward update doesn't work.
I brought a max speed rods turbo for my 2006 pathfinder not problems so far, but when installing we had to machine the oil feed pipe to fit on the turbo flange because the turbo was bot machined right and no matter what we did we couldn't get a flush seal, in the end we got it as best we could ,it still has a slow leak very slow like very slow haha.
But the turbo performs well.
Hey mate, did you try a small bead of oil resistant gasket goo? I've just ordered a maxpeedingrods turbo for my d22
Great work Des, when you do come to 🇦🇺 and if your in Melbourne, please look me up for a 🍺🍻. Your knowledge and DIY videos have heaped so many around the world. Many thanks 🙏🏽 👌🏽
Bet you have never been on west yorkshire engine scams on facebook you really would not want this toe rag any wear near you.
Oil supply is the biggest killer, be it lack of oil, dirty oil, or diluted oil. I have had turbos last 20 years of proper hard use on a well maintained engine.
TrueBlueEG8 Thanks for your thoughts buddy
Exactly
J'aurais aimé que ça soit moi dommage la prochaine fois merci pour tes vidéos 👍✌️💪
hey boeta thanks for all the help i now know my d40 in and out
Congrats on the winner👍I have 180,000 on my 2011 Nissan ute, sometimes ute stalls then goes away what sort service should I do next service?
Suction control valve is cheap, either fuel filter or worse thing is timing chain slack
Very good information, too bad can't understand you because of audio quality and pronunciation and I have a YD25DDTI D23 and needed to hear what you said on multiple occasions and couldn't
Hi Des, thanks for all the knowledge shared so far, but I'm stuck with a problem again, had my turbo overhauled, re-installed it, boosts fine drives fine but I'm getting pressure build up in my cooling system which has been blead multiple times. Any thoughts on what the issue could be, I don't have any bubbles in my coolant and no smoke at all, I am completely stumped.
Cracked cylinder head sorry to say
Thanks for the reply I'll have it stripped 1st thing in the morning
Just out of interest when are you going to do the V6 engine rebuild. I’m really looking forward to seeing this one 👍
he did it on facebook you can find it on " westyorkshireenginesscams"
Bro have you got any videos how to change a turbo on the navara as i got one to do tomorrow and need some insight
Nice video. In my country we don't have emission regulations and I'd like to blank my 2012 navara d40 egr, how do I go about it and will I get my engine light on after doing it? Spanish made
Do you have any videos of a brake booster leaking or a vacuum leak on a d40 please.we have change disk bled the brakes and put braided lines but still a spongy brake pedal.thank you
Dez dont no how to answer that question he's still scratching his head how to rip you off xx
Hi kindly confirm for me if the yd25 transfer case is compatible with qd32 gear box or Td27
Hi There just a question is there a fault finer diagnostic function for A/C on a 2013 Nissan Navara D40 ST model and if so could you do a video on one
please
Hi mate. Was thinking a getting of getting a nissan qashqai 2016 1.5 diesel. Whats your opinion on them? Are they reliable? Is there any faults i need to look out for? And what can i do to keep it in top shape? Cheers buddy
Cheez Luiz dpf mainly buddy
G,day🇦🇺 I need HELP!!! I've got a 2009 4x4 D40 auto,, 120,000km odo at purchase,, I'm the 2nd owner,,I get it serviced every 5,000km,, original engine shit it's self at 198,000km odo,,,got a second hand engine with 172,600km odo fitted, now getting to 220,000 km odo today starting to see vapour Fumes coming out the dipstick tube,,, just wondering what other engine brand can be fitted?? Because this D40 engine's are lemons & making me sick in the guts!
Wish you guys were in Australia!
Same mate! Would 100% use them over anyone else!
You don't..lol
Haha he's the biggest con man screwed so many people over here in uk takes your money and ruins your ute
He’s not trusted over here in the uk has conned a lot of people out of money just do a google search on his company you will be surprised
He couldn’t fix a Tonka toy let alone a real one🙈
Hi mate! Looking at buying a 2011 Nissan Navara ST 2.5lt Auto! ( Thai made ) has okay service history and 185,000kms on the clock.. can you see it lasting a long while longer!? Cheers
Any aftermarket turbos youd recommend over OEM for the yd25 mate?
Have you had anything to do with the stx 550? Looking at ugrading my stx and the v6 diesel is very tempting. The engine is the v9x and its paired the a 7 speed auto.
Why does my 2018 Nissan Navara lose power and shuts down? Is it my turbo system or what? After I reset the computer by disconnecting the battery and reconnecting the battery its ok until it trips a circuit...not sure what the problem is..thanks for your response 👍
Hi buddy should that not be under warranty?At the moment we haven’t had much to do with them sure that’s a good thing 😊
Hey guys my name is Rick from Australia just out of Melbourne and watch your videos all the time and I've got a 2010 D40 with no boost and lots of black smoke and I've done a EGR block checked and cleaned the EGR and replaced the boost solenoid with a genuine nissan one and only a slight change, revs quicker but still no boost no power if your pulling out on the highway you have to make sure you leave heaps of room to get to a 100klms, also checked all vacuum lines and I did the squeeze test with my wife giving it a big rev and it sucks the hose flat? I'm not really up there with diesels so any help would be much appreciated cheers guys
Boost sensor fault
Des, why are remaps terminal for the engine?
They just arent, some remaps can make an engine last longer, especially if they are tailored to the purpose of the vehicle, and driving style.
depends if you remap for more power then your putting pressure on the already shit injectors , timing chains and cranks.
P1028 and p1027 codes think linked to 4 wd any ideas on fix thanks
Bloody ripper mate an Aussie won cool
P1275 fault code nizzan navarra can you help me plz
Start with trying to clear the code or disconnect the battery
Can a gt30 gt35 or hx35 work on yd25ddti??
Hi where can i buy this duplex timing chain conversion kit for yd25 Nissan engine? From Philippines
Paul Gate's is your man
Lack of oil changes kill turbos change the oil every 5000km or 7500km its cheap insurance.
How is your new cell mate going Des??
Nope I have a smart phone 😊
@@westyorkshireengineservice9160 i herd he has the bottom bunk, did you explain to him about your blown ring gear.
Dave Allen 😂
Am getting a code p012b can anyone help me out please
Pissed or high as usual
Yep fake name as usual 😳😆
@@westyorkshireengineservice9160 who the fuck uses their real name COWBOY DES.
Tall Guy Cowboys never use there own name Tall guy does that mean your Tall 🤔😂
You havent got a clue.