😂 I was wondering why it was so hard for me lol now I know you gotta take the bolt off to extend the hose 😂 I was like this is stupid is not long enough lol
Can confirm an impact gun on full power got my second set of disk screws out, they were rusted, I drilled the first set out after chewing them up with a rachet by hand ... Hassle!
Hi, look closely at the start, he uses a screwdriver to press the caliper pistons back using the existing pads. Very smart if you don't have the piston clamp tool.
If you don't have the tool to compress the piston you're best off putting the old pad on the piston and using a set of large multi grip pliers to evenly compress the piston, way easier and safer on the piston.
Are those lil springs are important?
😂 I was wondering why it was so hard for me lol now I know you gotta take the bolt off to extend the hose 😂 I was like this is stupid is not long enough lol
how much of a difference can it make to not put on the wire that connects them both
Not alot, only when you dont have grease on the slide pin . It just helps to undo the braking a little
...what year?
Thanks. I was wondering about the brake hose. Disconnect from body.
good video
Как. Рыть диск у. Узды )-2004 мазда 6 .есть
Can confirm an impact gun on full power got my second set of disk screws out, they were rusted, I drilled the first set out after chewing them up with a rachet by hand ... Hassle!
First put the correct bit in and slap it hard with a hammer. The they will come loose easily
He dont use any caliber fat to screws, and to the bracket
Lug nuts tightened incorrectly..
Star pattern, yo.
(I'm sure you tightened them the same way you used the air tool, but you cut the video off..)
You didn't show how to compress the caliper and didn't use a drop of brake grease
Hi, look closely at the start, he uses a screwdriver to press the caliper pistons back using the existing pads. Very smart if you don't have the piston clamp tool.
If you don't have the tool to compress the piston you're best off putting the old pad on the piston and using a set of large multi grip pliers to evenly compress the piston, way easier and safer on the piston.
Made that look so hard why?
Turn off that fkn awful music
Too bad thats a mazda 3