Volkswagen MK2/MK3 Golf/Jetta CV axle removal from transmission

[@michaelpartridge6464]

Hi I managed to just put on axle stand and get to bolt with turning the wheel at same time haha !! but thanks useful info . wish I was just doing that !!!.

[@edwardlouis6228]

Does this include 92 jettas? There's no vid anywhere for my car

[@estacaco33]

Yes it does!

[@JamesKelly89]

I have a MK6 and I'm pretty sure it's the same. I need to get the axle out of the way to swap a faulty emissions component on mine.

[@Soranovano]

hey so I got one off of a 94 mines a 93 and the end of the CV joint looks completely different ... I just assumed they were the same.

[@estacaco33]

They should be the same.

[@captain_autisimo4747]

SPIDER SCARED DA FUCK OUTA ME

[@ThaHammieJaassee]

This is so help full I have a mk4 1.8t engine and tranny that I'm going to swap into my 87 gti :) and idk if I'm gonna be able to do it

[@estacaco33]

It's defiantly possible and has been done. Here's a thread with pictures.
forums.vwvortex.com/showthread.php?808137

[@meltvanniekerk4247]

what do you call that special key to remove the bolds

[@estacaco33]

+Frikkie van wijk It's called a triple square bit, 12 point bit, Serrated bit, or ZXN bit. I believe this one is 8mm

[@redbrown5721]

Does the axle nut have a cotter pin?

[@estacaco33]

No the axle nut does not have a cotter pin.

[@nickbullis288]

where can I get these bolts? I need a set for an axle

[@ThaHammieJaassee]

Nick Bullis autozone

[@sswise1977]

Driver side you have to lift engine with automatic

[@ecdsxxiecdsxxi5582]

good job. thanks.

[@ianhennessy3161]

It's the same on the mk1

[@keonnewilliams9511]

I need fancy tool car already loosened from other end need to clean greasy💩💩💩💩thanks