*** Update. Dorman Failed After about a year. Could be lack of calibration? Not sure. Seemed to operate perfect untill.... The noise. That terrible noise. Anyway, replaced with "A-NAFTULY HVAC Blend Door Actuator" "Model AN70011" Before installing actuator, connected power to confirm a closed position and span of actuator. Removed power. Installed in closed position. Operation check before installing bolts/screws. Looks dope. Hopefully no update needed in the future. A-NAFTULY HVAC Blend Door Actuator Replacement for Chrysler 200 2012-2014/Sebring, Dodge Avenger/Journey/Caliber, Jeep Wrangler/Patriot/Compass Ram-Heater Air Door Actuator Motor, 604-029, 68018109AA a.co/d/1NfMdQN
I just took my actuator off, cycled it, and reinstalled it, it worked fine after that. I think it's actually the plastic coupler was skipping in the pivot.
Only video I've seen on the passenger side actuator. Didn't even know there was one there. Thanks for taking the time to make it.
My blend door goes up and down but it makes a grinding noise and I have no heat. What would cause that.
Thanks for the video, it was a great help.
Thanks brother your a God sent everything right on point I did mine with help from you and it was hard but possible thanks a bunch
*** Update. Dorman Failed After about a year. Could be lack of calibration? Not sure. Seemed to operate perfect untill.... The noise. That terrible noise. Anyway, replaced with "A-NAFTULY HVAC Blend Door Actuator" "Model AN70011" Before installing actuator, connected power to confirm a closed position and span of actuator. Removed power. Installed in closed position. Operation check before installing bolts/screws. Looks dope. Hopefully no update needed in the future.
A-NAFTULY HVAC Blend Door Actuator Replacement for Chrysler 200 2012-2014/Sebring, Dodge Avenger/Journey/Caliber, Jeep Wrangler/Patriot/Compass Ram-Heater Air Door Actuator Motor, 604-029, 68018109AA a.co/d/1NfMdQN
thaks for video, great help
I just took my actuator off, cycled it, and reinstalled it, it worked fine after that. I think it's actually the plastic coupler was skipping in the pivot.
I ended up leaving that back screw out. No matter how hard i tried. Still wrkin fine.
Very hard to get up in there
Working blind
Trying my best to see
There was huge rodent on the hood in that picture